Publicidad
Idiomas disponibles
Idiomas disponibles
Overview
• Remove packaging materials from snow blower.
• Rotate Handle into the upright position and lock the handles
in place. Refer to Handle Assembly.
• Install the chute. Refer to Chute Assembly Options.
• Complete snow blower assembly. Refer to Set-Up on page
11.
Tools Required
• Adjustable Wrench or Socket Set
Assembly
1. Charge batteries. Refer to Charging a Battery on page 8.
2. Remove nut (a) and bolt from (b) lower handle (Figure 3).
3. Using the nut and bolt removed in STEP 3, secure the handle
sensor (c) to the lower handle.
Figure 3
4. Flip the two handle levers down to the Unlocked position
(Figure 4).
NOTE: if the handle lever does not flip down, loosen the wing
knob until the handle lever will flip down.
ASSEMBLY
c
a
b
5. Pivot the upper handle into the operating position. Be sure not
to pinch any of the cables in the process (Figure 4).
6. Flip the two handle levers (unlocked in STEP 4) up to the
locked position to secure the upper handle in the operating
position (Figure 5).
NOTE: Ensure the nub of the left handle lever engages the slot of
the handle sensor.
NOTE: If necessary, adjust the wing knob so that the handle
lever is tight enough to hold the upper handle in the operation
position but loose enough for the handle lever to flip down
to unlock the upper handle to be folded down to the storage
position.
10
Figure 4
Figure 5
Publicidad
