Publicidad
Idiomas disponibles
Idiomas disponibles
PR©DUCT $PEC-UFROATiON$
MODEL NUMBER
917.877580
SERIAL NUMBER
-DATE OF PURCHASE
HORSEPOWER:
6.75
DISPLACEMENT:
12.56 CU. IN.
GASOLINE
CAPACITY/TYPE:
1.5 QUARTS
UNLEADED
REGULAR
OIL TYPE (API-SFISG/SH):
SAE 30 (ABOVE 32°F)
SAE 5W-30 (BELOW 32°F)
OIL CAPACITY:
27 OZ&
SPARK
PLUG(GAP:
°030")
CHAMPION
J19LM
VALVECLEARANCE:
INTAKE:
°004 - ,,008
EXHAUST:
.004 - °008
SOLID STATE IGNITION
AIR GAP:
.0125 IN.
BLADE BOLT TORQUE:
35_40 FT. LBS.
The model and serial numbers will be found on a decal attached to the rear of the
lawn mower housing.Record
both serial number and date of purchase
in space
provided above.
LAWN MOWER
Always observe safety rules when performing
any maintenance.
TIRES
o Keep tiresfree of gasoline, oil, or insect
control chemicals which can harm rubber.
o Avoid stumps, stones, deep ruts, sharp
o Remove blade and attaching hardware
(bolt, look washer and hardened washer).
NOTE: Remove the blade adapter and
check the key inside hub of blade adapter°
The key must be in good condition to work
properly. Replace adapter if damaged,
TO REPLACE BLADE
objects and other hazards that may cause
tire damage.
BLADE
CARE
For best results, mower blade must be kept
sharp, Replace bent or damaged blades.
TO REMOVE BLADE
o Disconnect spark plug wire from spark plug
and place wire where it cannot come in
contact with spark plug.
o Tum lawn mower on its side. Make sure air
filter and carburetor are up.
° Use a wood block between blade and
mower housing to prevent blade from
tuming when removing blade belt.
° Protect your hands with gloves and/or wrap
o Position the blade adapter on the engine
crankshaft° Be sure key in adapter and
keyway in crankshaft are aligned,
o Position blade on the blade adapter
aligning the two (2) holes in the blade with
the raised lugs on the adapter.
o Be sure the trailing edge is up toward the
engine°
. Install the blade bolt with the lock washer
and hardened washer into blade adapter
and crankshaft.
° Use block of wood between blade and
lawn mower housing and tighten the blade
bolt, tuming clockwise.
. The recommended tightening torque is 35-
40ft. Ibs.
IMPORTANT. Blade bolt is grade 8 heat
treated.
blade with heavy cloth.
Remove blade bolt by tuming counter-
clockwise. Use a 9/16" box or open-end
wrench,
11
Publicidad
