HomeMatic HmIP-ESI-IEC Manual De Instalacion Y Uso página 20

Changing the batteries
7 Changing the batteries
If an empty battery is displayed in the
app or on the device
codes and flashing sequences" on page
22), replace the used batteries with
two new LR6/Mignon/AA batteries. You
must observe the correct battery po-
larity.
To replace the device batteries, please
proceed as follows:
• Remove the cover (B) to open the
battery compartment (F)
illustrations).
• Remove the used batteries.
• Place the two new 1.5 V LR6/Mi-
gnon/AA batteries in the battery
compartment (F) in accordance
with the polarity markings.
• After inserting the batteries, pay
attention to the flashing sequen-
(see „8.3 Error
(see
ces of the LED
and flashing sequences" on page
22).
• Put the cover (B) back onto the
mounted electronics unit (D), en-
suring that it latches fully into
place.
Once the batteries have been inserted,
the device will perform a self-test for
approx. 2 seconds. Afterwards, ini-
tialisation is carried out. The LED test
display will indicate that initialisation
is complete by lighting up orange and
green.
Caution! There is a risk of explo-
sion if the battery is not replaced
correctly. Replace only with the
same or equivalent type. Never
recharge non-rechargeable bat-
teries. Do not throw the batteries
into a fire. Do not expose batteries
to excessive heat. Do not
short-circuit batteries. There is a
risk of explosion
After replacing the batteries, you
may need to update the meter
reading to display the correct data
again.
(see „8.3 Error codes
20