Craftsman 125.12002 Manual De Instrucciones página 11

Maintenance (continued)
Installing & Cleaning Foam Sleeve Filter
Installing Foam Sleeve Filter
1. Verify that the power cord is
disconnected from the outlet. (Fig.l)
2. Remove power head and place
in upside down position. Follow
instructions to remove cartridge filter.
3. Carefully slide foam sleeve filter down
over the filter cage making sure the
whole cage is covered. (Fig. 2 & 3)
4. Replace the power head on to the
collection tank.
Cleaning Foam Sleeve Filter
1. With the removed power head in the
upside down position, carefully remove
foam sleeve filter. (Fig. 4)
2. Use a mild soap and water solution
to wash foam sleeve filter and rinse
with clean water. (Fig. 5)
3. Mow filter to air dry before installing
and using again.
InstaJling and Cleaning HEPA Filter
1. Verify that the power cord is
disconnected from the outlet. (Fig.l)
2. Unlock the filter door by lifting the lock
tab UP to the unlocked position and
pull the door out. (Fig. 2 & 3)
3. Remove the HEPA filter cartridge from
the vacuum. (Fig.4)
4. Clean filter by brushing dirt off. For
optimal performance a new filter is
recommended. (Fig.5)
5. Install the cleaned or new filter into
place. (Fig. 6)
6. Insert the filter door tabs into the upper
slots and lock the filter door into place.
(Fig. 7 & 8)
11