Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO INSTALL THIS SMOKE ALARM:
1. Hold base firmly and push the hinge in then turn
anti-clockwise, unload the base. If you don't have enough
power to separate the base, you can do as diagram4 shows.
2. Hold the smoke alarm base against the ceiling (or wall)
and make a mark at the center of each of the mounting slots
with a pencil.
3. Place the unit where it won't get covered with dust when
You drill the mounting holes.
4. Using a 6.5mm drill bit, drill a hole through each pencil
mark into 35mm depth.
5. Insert the plastic screw anchors into the holes and tap
them gently with a hammer. Tighten the 3*30 screws into the
screw anchors, and then loosen them two turns. Refer diagram 5.
6. Slide the smoke alarm base up to the screw heads to match with the narrow ends of the mounting slots, and then
tighten the screws completely.
7. If the battery is needed, unscrew the screws fixing the battery cover, and insert the 9v battery into the box, then
close the battery cover and tighten the screws, Refer Diagram 6.
8. Close the bottom cover and the alarm body, and then finish your installation.
TEST:
1. It is important to test this unit weekly to make sure it is working properly. Don't open the alarms by yourself, return
them to the seller if convenient, and don't use fire to test your alarms. But hold the test button on the cover of the
unit until the alarm sounds. If it does not alarm, make sure that the unit is receiving power and test it again. If it still
does not alarm, replace it immediately or check your battery.
2. The signal flashes once every30 seconds and while it alarms the signal will flash once 0.5 per second.
3. If the alarm makes low "chirp" sounds about every 30seconds,it tells you to exchange your battery.
4. Little smoke will not cause alarms, so misinformation occurs only when you blow smoke to the alarms directly or
you forget to turn on your ventilated facility while you are cooking.
5. Sometimes when you smoke, the unit will alarm, so you can just blow air to it to stop alarming.
HOW TO DO IN CASE OF FIRE:
1. Call the Fire Department immediately after confirming the fire.
2. Don't worry, stay calm and follow your family escape plan. Get out of the house as quickly as possible, don't stop
to get dressed or collect anything.
3. Feel doors before opening them to see if they are hot. If a door is cool, open it slowly. Don't open a hot door-use
an alternate escape route.
4. Cover your nose and mouth with a cloth (preferably wet). Take short, shallow breath.
5. Meet at your planned place outside your home, and count to ensure everybody go out safely.
NOTICE:
If the smoke alarm is alarming without smoke, please check whether there is fluorescent light in the side, If so,
please fix the product farther from the fluorescent light.
DIAGRAM 4
DIAGRAM 6
DIAGRAM 5
Publicidad
