Samsung 3 Serie Manual Del Usuario página 30

Display Modes
If the signal from the system equals the standard signal mode, the screen is adjusted automatically. If the signal from the system
doesn't equal the standard signal mode, adjust the mode by referring to your videocard user guide; otherwise there may be no
video. For the display modes listed below, the screen image has been optimized during manufacturing.
D=Sub and HDMI/DVI Input
"'_'?_""_-"'"°_"_!. Horzonta Frequency [--Ve_[ca]Frequency Pixel Clock Frequency SyncPoarty
IBM 640 x 350 31.469 70.086 25.175 +/-
i 720 x 400 31.469 70.087 28.322 -/+
832 x 624 49.726 74.551 57.284 -/-
1280 x 720 44.772 59.855 74.500 -/+
1280 x 720 56.456 .................................... 74777 .................................................................................... 95:7#Q ..................................................... ................................ -/_+ . .................................
640 x 480
640 x 480
800 x 600
800 x 600
800 x 600
1024 x 768
1024 x 768
1024 x 768
31.469
37.500
37.861
37.879
46.875
48.077
48.363
56.478
60.023
1360 x 768 47.712
59.940
75.000
72.809
60.317
75.000
72.188
60.004
70.069
75.029
60.015
25.175
31.500
31.500
40.000
49.500
50.000
65.000
75.000
78.750
85.500
-/-
-/-
-/-
+/+
+/+
+/+
-/-
-/-
+/+
+/+
............... !280 x!2Q ............................... 52_59Q 7q:909 ............................................. 89:949 ................................ -_+ ..................................
When using an HDMI / DVI cable connection, you must use the HDIVlt(DVl) IN jack. (LN19B360, LN22B360)
When using an HDMI / DVI cable connection, you must use the HDMI IN 1 jack. (LN26B360, LN32B360)
C)
Setting up the TV with your PC
Preset: Press the SOURCE button to select PC mode.
Auto Adjustment
Use the Auto Adjust function to have the TV set automatically adjust the video signals it
receives. The function also automatically fine-tunes the settings and adjusts the frequency
values and positions.
_-_ Press the TOOLS button to display the Tools menu. You can also set the Auto Adjustment
by selecting Tools _ Auto Adjustment.
This function does not work in DVI-HDMI mode.
C] Screen
The purpose of the picture quality adjustment is to remove or reduce picture noise. If the noise is not removed by fine tuning alone,
then make the vertical frequency adjustments on your PC and fine tune again. After the noise has been reduced, re-adjust the
picture so that it is aligned on the center of the screen.
Coarse / Fine
The purpose of picture quality adjustment is to remove or reduce picture noise. If the noise is not removed by Fine-tuning alone,
then adjust the frequency as best as possible (Coarse) and Fine-tune again. After the noise has been reduced, readjust the picture
so that it is aligned on the center of screen.
PC Position
Adjust the PC's screen positioning if it does not fit the TV screen. Press the ,& or V button to adjusting the Vertical-Position. Press
the 41or _.button to adjust the Horizontal-Position.
image Reset
You can replace all image settings with the factory default values.