SmartGyro Crossover Dual max Guía Rápida página 14

EN
Maintenance
• Instructions for cleaning your Smartgyro.
If you want to keep your scooter looking like new, we recommend
cleaning it after each use with a soft, damp cloth (no abrasive
liquids). Then leave it in a place where it can be ventilated avoiding
the corrosion of metal parts. When you clean the scooter, make
sure it is turned off, unplugged from power and with the charging
lid closed. You cannot clean the scooter with a pressurized water
hose or submerge it in water since you could seriously damage it.
• Brake adjustment
The front and rear (disc) brakes of your Smartgyro Crossover Dual
MAX LR have two adjustment points: either through the handlebar
brake lever tensioner or through the brake cable/caliper. In both
cases, to be able to tighten them, you must turn the thread cloc-
kwise, and to loosen them, in the opposite direction. If you tighten it
from the caliper you have to loosen it with an allen key, tighten the
cable and tighten it again.
• Suspension adjustment
The suspensions do not need any kind of adjustment.
•Replace components such as brake pads, wheels, etc.
For this we recommend you enter our website smartgyro.es, go to
any of our official stores and workshops or enter our YouTube
channel to see tutorials @smartGyroOficial.
• Lubrication of important parts:
Add a small amount of grease or specific lubricant to always keep
the front and rear shock absorbers lubricated and all the neces-
sary areas of the scooter periodically from time to time to extend
the life of your scooter and that it is always ready.
REMEMBER:
• Avoid obstacles and anticipate the trajectory and speed respec-
ting the traffic code and the most vulnerable
• In any case take care of yourself and others.
13