Uline BUNN H-10900 Guía Rápida página 2

5. Press and release the START switch. Water will begin
flowing into the tank.
6. When water stops flowing into tank, repeat step 5 to
initiate a second and third brew cycle.
NOTE: During the third brew cycle, the tank will
fill to capacity. Excess will flow from spray head
and out of the funnel into the dispenser.
7. When flow of water stops, turn the heater switch to the
ON position.
NOTE: Water will take approximately 20 minutes
to properly heat.
NOTE: Some water may drip from funnel during
this time. This should not happen once water is
fully heated.
1. Insert BUNN filter into funnel.
®
2. Pour coffee grounds into filter.
3. Shake filter to level grounds.
4. Slide funnel into funnel rails.
• Clean and sanitize funnel periodically.
• Use a clean damp cloth rinsed in mild, non-abrasive
detergent to clean all outer surfaces.
• Check and clean spray head periodically.
Spray head holes must always remain open.
1. With spray head removed, insert a deliming spring
into spray head tube until two inches of spring
remains visible. Saw back and forth to loosen any
lime deposits. (See Figure 2)
2. Flush tube by running a brew cycle with a half empty
funnel and decanter. Replace spray head after
cycle is complete.
PAGE 2 OF 6
SETUP CONTINUED
8. Turn the batch selector switch to the 1 GAL position.
Press and release the start switch.
9. Turn the on/lower switch to the OFF position after
water has stopped flowing from funnel. Allow water
in tank reheat to proper temperature.
10. Brewer is now ready for use.
COFFEE BREWING
5. Place an empty decanter under funnel.
6. Turn the on/lower switch to ON position.
7. Press and release start switch.
8. When brewing is complete, discard grounds
and filter.
CLEANING
Figure 2
Spray Head
1-800-295-5510
uline.ca
Deliming
0823 IH-10900