Publicidad
USING YOUR ELECTRIC KETTLE
1. Place the kettle on the flat surface.
2. To fill the kettle, remove it from the power base and
open the lid by pressing down lid release button,
then fill the kettle with the desired amount of water
and close the lid. The water level must be within the
Min and the Max level. Too little water will cause the
kettle switching off before the water has boiled.
NOTE: Do not fill the water over the maximum
level, as water may spill out of the spout when
boiling. Ensure that the lid is firmly in place before
plugging the power outlet.
3. Position the kettle on the power base.
4. Connect the plug into a power outlet. Press down
the switch and the indicator will light up, and then
the kettle starts to boil the water. The kettle will
switch off automatically once the water has boiled.
If necessary, it will take you 30 seconds to wait
before pressing the switch again to re-boil the
BOIL-DRY PROTECTION
Should you accidentally let the kettle operate without water, the function of boil-dry protection will automatically
switch off the power. If this occurs, allow the kettle to cool prior to filling with cold water before re-boiling.
CLEANING AND MAINTENANCE
Always disconnect the appliance from the power outlet and cool it down completely before cleaning.
1. Never immerse the kettle, power cord or power base in water, or allow moisture to contact with these parts.
2. Wipe the appearance of body with a damp cloth or cleaner, never use a poisonous cleaner.
3. Remember to clean the filter at intervals. For easier cleaning, detach the filter by pressing down the tab of filter
inside the kettle and then replace it after cleaning.
CAUTION: Do not use chemical, steel, wooden or abrasive cleaners to clean the outside of the kettle to prevent
the gloss loss.
4. When not use or storage, the power cord may be wind under the bottom of kettle.
REMOVAL OF MINERAL DEPOSITS
Your kettle should be periodically descaled as the mineral deposits in tap water may form scale on the bottom of
kettle so as to cause the operation less efficiency. You can use the commercially available descaler and follow the
instructions on the package of descaler. Alternatively, you may follow below instructions using the white vinegar.
1. Fill the kettle with 3 spoons of white vinegar, then adding water to the amount so as to cover the bottom of
kettle completely. Leave the solution in the kettle overnight.
2. Then discard the mixture in the kettle, then filling the kettle with clean water to the maximum position, boiling
and then discard the water. Repeat several times until the odor of vinegar has been flushes away. Any stains
remaining inside the spout can be removed by rubbing with a damp cloth.
water. You may shut off the power by lifting switch
up or directly lift the kettle from the power base at
any moment to stop boiling process.
NOTE: Ensure that switch is free of obstructions
and the lid is firmly closed, the kettle will not turn
off if the switch if be constrained or if the lid is
opening.
5. Lift the kettle from the power base and then pour
the water.
NOTE: Operate carefully when pouring the water
from your kettle as boiling water may result in scald,
besides, don't open the lid while the water in the
kettle is hot.
6. The kettle will not re-boil until the switch is pressed
again. The kettle may be stored on the power base
when not in use.
NOTE: Always disconnect the power supply when
not use.
5
Publicidad
