Publicidad
Idiomas disponibles
Idiomas disponibles
PROGRAMMING
NOTICE: If this Security_
garage door opener is operated with a non-rolling code transm#ter, the technical measure in
the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented.
The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transm#ter to circumvent that technical measure,
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security÷ _R_'
remote controls.
To Add
or Reprogram
a Hand-held
Remote
Control
USING THE "LEARN"
BUTTON
USING THE PREMIUM CONTROL CONSOLE
1. Press and release the "learn" button
on the motor unit. The learn indicator
light will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold
the button on the hand-held remote*
that you wish to operate your garage
door.
3. Release the button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
1. Press and hold the button on the
hand-held remote* that you wish to
operate your garage door.
2. While holding the remote button,
press and hold the LIGHT button on
the Premium Control Console.
.
Continue holding both buttons while
you press the push bar on the
Premium Control Console (all three
buttons are held).
4. Release buttons when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
\l
/
To Erase
All Codes
From
Motor
Unit
Memory
To deactivate any unwanted remote, first
IlI_]
II
erase all codes:
Press and hold the "learn" button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous
codes are now erased. Reprogram each remote or keyless
entry you wish to use.
35
*3-Function
Remotes
If provided with your garage door opener, the large
button is factory programmed to operate it. Additional
buttons on any
Security÷ _ 3-Function
remote or compact
remote can be
programmed to operate
other Security÷ '_garage
door openers.
Publicidad
