Descargar Imprimir esta página

Husqvarna 917.375830 Manual De Instrucciones página 19

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
- See appropriate
section in manual unless directed
to a Husqvarna
Parts & Repair Center.
CAUSE
PROBLEM
Does not start
(continued)
Loss of power
Poor cut -
uneven
Excessive
vibration
Starter rope
hard to pull
Grass
catcher
not filling
(If so equipped)
Hard to push
Loss of drive
or slowing
of
drive
speed
9.
Control
bar defective.
10. Fuel valve lever (if so
equipped)
in OFF position.
11 .Weak
battery
(if equipped).
12. Disconnected
battery
connector
(if equipped).
1.
Rear of mower
housing
or
blade dragging
in grass.
2.
Cutting
too much grass.
3.
Dirty air filter.
4.
Buildup
of grass,
leaves,
and trash under mower.
5.
Too much oil in engine.
6.
Walking
speed
too fast.
1.
Worn,
bent or loose
blade.
2.
Wheel
heights
uneven.
3. Buildup of grass, leaves
and trash under mower.
1.
Worn,
bent or loose
blade.
2.
Bent engine
crankshaft.
1.
Engine
flywheel
brake is on
when control
bar is released.
2.
Bent engine
crankshaft.
3.
Blade adapter
broken.
4.
Blade dragging
in grass.
1.
Cutting
height
too low.
2.
Lift on blade worn off.
3.
Catcher
not venting
air.
1.
Grass
is too high or wheel
height
is too low.
2.
Rear of mower
housing
or
blade dragging
in grass.
3.
Grass catcher
too full.
4.
Handle
height
position
not
right for you.
1.
Belt wear.
2.
Belt off of pulley.
3.
Drive cable worn
or broken.
4.
"Loose"
drive control
system.
CORRECTION
9.
Replace
control
bar.
10.Turn
fuel valve lever
to the ON position.
11. Charge
battery.
12. Connect
battery
to engine.
1. Raise cutting
height.
2.
Raise cutting
height.
3.
Clean/replace
air filter.
4.
Clean
underside
of mower
housing.
5.
Check
oil level.
6.
Cut at slower walking
speed.
1. Replace
blade. Tighten
blade bolt.
2.
Set all wheels
at same
height.
3.
Clean
underside
of
mower
housing.
1. Replace
blade. Tighten
blade bolt.
2.
Contact
a Husqvarna
or other
qualified
service
center.
1. Depress
control
bar to
upper handle
before
pulling
the starter
rope.
2.
Contact
a Husqvarna
or other
qualified
service
center.
3.
Replace
blade adapter.
4.
Move lawn mower
to cut
grass or to hard surface.
1. Raise cutting
height.
2.
Replace
blade.
3.
Clean
grass catcher.
1. Raise cutting
height.
2.
Raise rear of mower
housing
one (1) setting
higher.
3.
Empty
grass catcher.
4.
Adjust
handle
height
to suit.
1. Check/replace
drive belt.
2.
Check/reinstall
drive belt.
3.
Replace
drive cable.
4.
Adjust drive control.
19

Publicidad

loading