Orbegozo DA 5650 Manual De Instrucciones página 8

DA 5650
3. FILTER INSTALLATION
- Remove the filter from its packaging, put inside a bowl with water and let it submerged for 10 minutes.
Put the filter under water running for 10 seconds.
- Insert the filter in upper water tank and make sure it fits well in its place.
- Full fill upper water tank with water for filtering it. Discard this water (it is normal for carbon deposits to
appear in the discarded water).
- After this process you can consume the filtered water.
4. USING
- This water dispenser only incorporates the water cooling function.
- The appliance has in bottom back side a ON/OFF switch which turn on and turn off water cooling system.
- When the switch is in ON position, tap provides cool water and when the switch is in OFF position, tap
provides natural water, i.e., water at room temperature.
- When orange LED light (1) is illuminated the appliance is ready for cooling water.
5. BASIC OPERATION
- Always unplug the water dispenser from the wall outlet when out of water.
- Locate the water dispenser cooled by semiconductor in a well-ventilated area making sure there is at least
2"（about 5 cm) of clearance around the back of it for proper airflow.
- Do not incline the water dispenser when using, otherwise water-leak may be happened.
- To help prevent algae growth, do not place water dispenser in direct sunlight or in front of heating vents.
- Before plugging in, check the power label on the rear of the unit to ensure the power supply is Correct.
- Serious damage could result if the incorrect supply is used.
- Never rest cigarettes on water dispenser top. Do not use it as a shelf for plants or storage of other objects.
Keep area around water dispenser free of dust and dirt.
- If water accidentally splashes inside the water dispenser, unplug the unit, remove excess water and dry
out before putting back into service.
- Do not locate water dispenser in area where the temperature may fall below freezing. If ice-jam
happened, let water dispenser stand for a few minutes to allow any ice in the reservoir to melt. Add hot
water to speed up this process, and at the same time, remain the power off for a longer period of time
when no one is using it, and this saves energy and prolongs the lifetime of the semiconductor.
- Never place the water dispenser out of doors, and it is not suitable. Please do not use it in water-spraying
condition; the water dispenser also cannot be sanitized by way of water-spraying.
- Silent motor.
6. HOW TO CLEAN AND SANITIZE YOUR WATER DISPENSER
It is recommended clean and sanitizes regularly the water dispenser to ensure the quality of consumed
water. For the outside, use soft cloth slightly moistened with hot soapy water. Avoid using abrasive cleaners
which can scratch the surface. Do not use cleaning products with chemist components which can damage
the plastic surfaces and erase the original shine and touch. For inside, follow the same process than point 2.
7. HOW TO REMOVE MINERAL DEPOSITS
- Use a solution of distilled vinegar and water, and scrub reservoir with sponge or cloth.
- Do not use steel wool to clean reservoir. This will leave small metal filings in the reservoir and it will
eventually damage it.
8