Armada Technologies Pro881 Instrucciones página 4

compartment. Don't yank or pull hard on the battery boot. Finally,
replace the battery cover.
To test that the batteries have been correctly installed, turn each unit
on. The control panel LEDs will come on if the batteries have been
connected correctly. If not, repeat the installation procedures. The
transmitter battery compartment is designed to hold the batteries
tightly so if the unit doesn't turn with the power button, try adjusting
the batteries by rolling them or moving them forward and backward
until the power does come on.
Battery Condition Indicators – The transmitter control panel has an
LED light above the power button that indicates battery condition.
When the light is on, battery power is low. When the light is off, the
battery condition is good. As for the wand, the battery condition is
also indicated by an LED light. This light is above the volume control
on the wand. Once again, when the light is off, the battery is in good
condition, and when it is on, the battery is low. Always be sure to
check your battery conditions in both the transmitter and the wand if
you are having any trouble using the locator. This is a common
problem users run in to.
4