Craftsman 917.28913 Manual De Instrucciones página 21

_traSos dentro
: use anteojos
o cuando
de segu-
seguridad
ruptor de la
ra que "STOP"
rgue (muerta),
;, cuando el
andando en
notor caliente
ponga "caf&"
iempre pare
;n _.reas con
e el tractor
scrito anted-
posici6n del
LA
;eleraciSn
ocidad inferior
miento dis-
.me a la veloci-
.ANTE Y HA-
_ovimiento son
Lnca de cambio.
el pedal
Ldoy con la
:ici6n de neutro
, a la posici6n
le embrague/
_ovimiento.
:tor pare
cambios o de
hace 1oan-
de su transejeo
_E CORTE DE
antamiento del
corte
niento_
:o pulgar y
n deseada.
; de aproxima-
ts alturas se
de la cuchi!la
ando. Estas
en variar de-
_1suelo, de la
:6sped que se
WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY
SERVICE OR ADJUSTMENTS:
1, Depress clutch/brake pedal fully and set parking brake_
2, Place gearshift lever in neutral (N) position,
3. Place attachment clutch in "DISENGAGED" positiono
4. Turn ignition key to "STOP" and remove key. i
5. Make sure the blades and al! moving parts have completely stopped.
6. Disconnect spark plug wire from spark plug and place wire where it cannot
come in contact with plug,
TRACTOR
TO REMOVE MOWER
Mower will be easier to remove from the
right side of tractor.
I_ Place attachment clutch in "DISEN-
GAGED" position°
2, Move attachment lift lever fonNard to
lower mower to its lowest position_
3_ Roll belt off engine pulley.
4. Remove small retainer spring, and re-
move clutch spring off pulley bolt.
5_ Remove large retainer spring, slide col-
lar off and push housing guide out of
bracket°
6, Disconnect anti-sway bar from chassis
bracket by removing retainer spring,
7_ Disconnect suspension arms from rear
deck brackets by removing retainer
springs.
8. Disconnect front links from deck by re-
moving retainer springs,
9. Raise lift lever to raise suspension arms.
Slide mower out from under tractor_
IMP O RTANT: If an attachment other than the
mower' deck is to be mounted on the tractor,
remove the front links and hook the clutch
spring Into square hole in frame.
TO INSTALL MOWER
1. Raise attachment lift lever to its highest
position,
2. Slide mower under tractor with deflector
shield to right side of tractor.
3. Lower lift lever to its lowest position,
4. Connect front links to mower deck and
secure with retainer springs,.
5_ Connect suspension arms to rear deck
brackets and secure with retainer
springs.
6. Connect antFsway barto chassis bracket
and secure with retainer spring.
7. Push clutch cable housing guide into
bracket, slide collar onto guide and secure
with large retainer spring.
8. Place flat washer and clutch spring on
idler pulley bolt and secure with small
retainer spring.
9. Install belt onto engine pulley.
Small Retainer S
Clutch S_
Small Retainer Spring
Clutch Spring
Front Link
Retainer Spring--._
Anti-Sway Bar
Co
Housing
Guide
Retainer Springs
Both Sides)
Large Retainer Spring
Bracket
2I
Deflector Shield