Xblitz Z9 Manual Del Usuario página 10

make random fragments of route recordings. If the functions are deactivated,
check if the fault occurs without a memory card inserted.
5. The camera records fragments of the route / randomly lasting recordings.
Check: MOVEMENT DETECTION - function designed to operate while the vehicle
is parked.
You need to deactivate the function, before setting off, as it may cause the
camera to switch on and off and make random fragments of route recordings.
If the function is deactivated, check if the fault occurs without a memory card
inserted.
6. The device shows the message "card full" or does not read the card.
Check the "G-sensor" and "parking mode" functions and set them to minimum.
The card must be formatted in the computer in the FAT32 or exFAT file system
(depending on the card) and then in the recorder.
Check also: Whether the selected card capacity and its specification (micro
SD, class 10 - U1, V10 additionally recommended) is suitable for your device
(we recommend using cards from reputable manufacturers, we recommend:
Kingston, Samsung, Sandisk).
If at any stage you encounter an error, replace the card with a new one from
official distributors.
7. The device records noisy, distorted, unclear sound.
The device has a very sensitive microphone which records any ambient noise.
Recorded sounds may overlap. Windscreen air vents may also distort the sound.
8. The device does not respond.
Briefly press the Reset button or reset the device to factory settings.
9. Transverse stripes appear on the recording.
Incorrect setting of the frame rate value. Set the frequency value to "50Hz" or
"60Hz" depending on local settings.
10. Mount detaches from glass/does not stick to glass.
Degrease the surfaces well before mounting the mount on the glass. Remember
to avoid high temperatures, which can cause deformation of the holder, and
damage to the recorder itself.
NOTES:
- G-SENSOR - a function by which recordings with recorded overloads (e.g. uneven
pavement, braking, driving off a kerb or over a speed bump, etc.) are protected
from being overwritten. If you use this function, you must periodically format the
memory card on your computer and then on the camera. Ultimately, each file on
the data carrier will be protected from being overwritten and the device will not be
able to record a further route - it will not record in a loop. We suggest setting the
sensor according to your driving style and road conditions. This option can also be
completely disabled, in which case each oldest file will be overwritten and the card
18
will not need to be formatted periodically.
- PARKING MODE/MONITOR - a function designed to operate while the vehicle is
parked, uses battery power* if the recorder is fully charged - (*if it has a built-in
battery) . In this case, the camera starts recording a few seconds of video after
detecting a shock - until the battery is discharged. When using this function, bear
in mind the battery of the device, which needs to be recharged after the function
activates (starts). You should deactivate the function, before setting off on a jour-
ney, as it may cause the camera to switch on and off and make random fragments
of route footage.
*The constant power supply in the vehicle may cause this function to behave
differently, e.g. leaving the camera on, which may drain the car battery.
- MOVEMENT DETECTION - a function designed to operate while the vehicle is
parked - requires a constant power supply and the camera must be left on. The
camera will start recording automatically when motion is detected, and will stop
recording a few seconds after there is no movement in front of the camera lens.
Please note that this function can drain the car battery.
It is necessary to deactivate the function, before setting off on a journey, as it may
cause the camera to switch on and off and make random fragments of recordings
from the route.
05. SAFETY MEASURES
1. Do not disassembly or interfere with the camera. If the device is faulty,
contact the service point.
2. Only use the original accessories.
3. Use only the original charger, included in the set. Using a different power
supply can affect the battery negatively.
4. Do not use the device for purposes that are against the law of the country
region you are in.
5. The operating temperature of the device is 0 - 35°C. Storage temperature
5°C to 45° . Operating air humidity is 5-90% without condensation.
6. Avoid damaging the device with physical force.
7. Clean the device, especially the lens. Do not use detergents or other chemi-
cals when cleaning the device.
8. Clean the device only when it's disconnected from the power supply.
9. Keep the device away from children.
10. Do not expose the device to very high temperatures and fire.
06. TECHNICAL SPECIFICATION
Processor: JL5601 | Sensor: GC2023 | Lens: 4G | Video resolution: Full HD
1920x1080/30fps | View angle: 140° | Memory cards: micro SD up to 64GB
capacity class 10th | Video file format: MOV | Photo storage format: JPG | Power
19