Deltaco SH-DB02CHIME Manual Del Usuario página 6

ENG
User Manual
1. LEDs (status)
2. Speaker
3. Volume button
4. Ringtone button
5. Pairing button
6. USB Micro-B
Compatibility
This product is only compatible with
SH-DB02.
Pairing
You can connect up to 8 chimes to
SH-DB02.
Press and hold the paring button for
2 seconds to pair.
When the red LED flashes slowly, it
is ready to be paired.
Press the button on your smart
doorbell camera (SH-DB02) to pair.
To reset the chime press and hold
the pairing button for 5 seconds.
Volume
Press the volume button to change
volume. Each press changes the
volume until it resets at default
volume. After just being paired, the
volume will be set to max volume.
Ringtone
Press the ringtone button to change
ringtone. Each press changes to
next ringtone. The blue LED flashes.
Batteries
3x AA batteries should be used with
this product.
Open the battery compartment to
replace the batteries. Observe
the polarity markings for + and -.
Replace the batteries. Close the
battery compartment. Do not mix
batteries of different type or old and
new batteries.
USB
This product can be powered by
USB. Connect a Micro USB cable to
the USB Micro-B port and to a USB
power adapter.
Cleaning and maintenance
Do not use cleaning solvents or
abrasives. Do not clean the inside of
the device. Do not attempt to repair
the device. If the device does not
operate correctly, replace it with a
new device. Clean the outside of the
device using a soft cloth.
Support
More product information can be
found at www.deltaco.eu.
Contact us by e-mail:
help@deltaco.eu.
FIN
Käyttöopas
1. Toimintatilan merkkivalot
2. Kaiutin
3. Äänenvoimakkuuden säädin
4. Merkkiäänen valintapainike
5. Laiteparin muodostuspainike
6. USB Micro-B -liitäntä