- Press the button (16) to stop operation of the device,
- When finished working, unplug the cord and coil it by pressing and holding the button (17).
Hold the cord firmly to prevent uncontrolled movement.
• TIPS AND TRICKS
- The vacuum cleaner can be stored in a horizontal position. There is a handle (18) on the back of the unit
to park the suction tube, and there is a corresponding clip on the brush (1).
- When vacuuming upholstery, small rugs or delicate fabrics, it is recommended to reduce the suction power
with the regulator (4).
- If the cord is jammed during retraction, it is recommended to unroll it slightly and try to retract it again
- Use the dual-function nozzle (16) to vacuum hard-to-reach areas (corners, crevices, etc.). This tip is also
equipped with a brush for removing dust from furniture, books, etc.
• EMPTYING THE CONTAINER
- Regular emptying of the containers ensures proper operation of the vacuum cleaner and maintenance
of optimal suction power.
- Turn off the device with the button (16) and disconnect the cord from the mains.
- Remove the hose end (6) from the socket (7) - fig. 2.
- Grasp the handle in the lid of the container (9), press the lock button (15) and, holding the handle (14),
remove the container (8) from the body.
- Over the garbage can, pull out the filter (12) from the garbage can, then press the lock button (10) and pull
off the lid (9).
- Remove the trash from the container, then replace the lid and close it.
- Clean the filter (12) over the garbage can, and then place the filter (13) in the container (8).
- When inserting the filter (12), the element (11) should be pressed into the lid of the container (9).
- Place the container (8) with the lid (9) on and the filter (12) installed in the body (25).
• CLEANING AND MAINTENANCE
- Before any maintenance or repair operations, turn off the device and disconnect it from the
- it from the power supply.
- Proper operation of the device is guaranteed by regular cleaning and replacement of filters (12,19)
and emptying the container (8).
- Clean the housing, equipment components and power cord with a soft, slightly dampened cloth
- with a little dishwashing detergent.
Do not immerse the device in water of another liquid substance.
- Do not use any harsh cleaning agents for cleaning that may damage the surface of the housing.
• FILTERS
- Check the condition of the filters (12, 19) regularly and clean them if necessary. The vacuum cleaner
is equipped with two filters:
§ internal - inlet filter (12) protects the motor from damage, among other things.
§ the external filter (19), is a protection against air pollution in the vacuumed rooms. The filter can be
accessed by opening the filter cover (20).
- Filters (12, 19) should be replaced periodically (after about 100 hours of operation).
- The filter set is available under the symbol IDF5901.
Filters are consumable items and are subject to natural wear, so they are not subject to replacement
under warranty.
• WARRANTY
- This appliance is designed for domestic use only.
- It cannot be used for professional purposes or for other than the intended use.
-
Improper use will nullify the guarantee.
11