MUHLER MCM-611 Manual De Uso página 9

EN: ESPRESSO MAKER 3IN1 CAPSULES AND GROUND COFFEE | Instruction Manual
cycle is completed.
CAUTION: Before cleaning, unplug the machine and let it cool down. Do not immerse the machine in water! It is strictly
forbidden to tamper with the internal parts of the machine. Change the water in the tank if not used for 3 days. To prevent
damage to the appliance do not use alkaline cleaning agents when cleaning, use a soft cloth and a mild detergent.
TROUBLESHOOTING
Problem encountered
Machine does not turn on. Power
lights are off after having pressed the
brewing buttons.
The machine requires a lot of time to
heat up.
The machine is very noisy.
No supply.
Water leaks at the rear side of the
coffee machine
Your beverage is splashing out of
coffee outlet.
STORING THE MACHINE:
If the machine remains inactive for a long time, unplug it and store it in a dry place out of reach of children. Keep it protected
from dust and dirt.
WARANTY
No liability is held for damage caused by:
• incorrect use not in accordance with the intended purposes;
• repairs not carried out by authorized service centre;
• tampering with the power supply cable;
• tampering with any parts of the machine;
• the use of non-original spare parts and accessories;
• failure to descale;
• storage at temperatures below 4°C (39,2°F);
• use in places with temperature below 10°C (50°F) or above 40°C (104°F);
Solution
Connected the machine to the power source. Connected the machine directly to
the power source.
Connect another device to check the power supply.
If the problem remains, please contact dealer
Check the surface.
Check the correct position of the cable into the base of the machine.
Fit the movable parts properly.
Top up the tank with fresh drinking water.
Insert right capsuleе.
If the problem remain please contact dealer
Press one of the buttons and check the operation of the pilot light (ON with white
blinking light) and the machine power-on. Top up the tank with fresh drinking
water. Insert the tank correctly.
Repeat the coffee machine power-on procedure.
If the problem remain please contact dealer
Insert the tank correctly.
Check for leaks in the tank keeping it separate from the machine.
If the problem remains, please contact dealer.
Stop preparation, pull out capsule holder and check capsule. There should be only
one hole in the capsule. Throw away capsule if there is more than one puncture
hole.
Insert a new capsule in the capsule holder and insert it back in the machine.
9