Publicidad
Idiomas disponibles
Idiomas disponibles
Aligning the wall
plate
REAR
WAL_TEMPLATE
Draw a Vertical
Line on
Area A
Centerllne
Wall from Center of Top
notches
"_
_* _----
Cabinet
_OoOoOoOoOoO
_
,OoOoOeOoOoOoO
7
Hodzontal
Une
Area
E
Horizontal
Une
Hole
C
Hole
B
Draw a Horizontal
line on wall from bottom of
"Rear Wall
Template".
CAUTION:
Wear gloves to avoid cutting
fingers on sharp edges.
1.
Draw a Vertical line on the wall at the center of the 30" wide space.
2.
Draw a Horizontal
line on the wall along the bottom of "Rear Wall Template".
3.
Drill 5/8"
holes for toggle bolts on 3 locations (Hole A, Hole B, Hole C) but if the location of hole is same as that of
stud, drill a 3/16" hole for wood screw. In other words, toggle bolt can not be used at the location of stud.
NOTE: DO NOT MOUNT THE PLATE AT THiS TIME.
NOTE: Holes A, B and C are inside area E. If none of A, B and C is in a stud, find a stud somewhere in area E and draw a
forth circle to line up with the stud. It is important to use at least one wood screw mounted firmly in a stud to support the
weight of the microwave. Set the mounting plate aside.
10
Publicidad
