Levenhuk Ermenrich NetGeeks NP10 Guia Del Usuario página 4

PoE test
This function is used to identify the pins that provide PoE, and the power supply mode.
Insert one end of the PoE cable into the RJ45 port (6) on the transmitter and the other end into the PoE equipment (such as network switch,
router, etc).
If the Midspan indicator (3) glows orange, it means that power is provided by midspan (4, 5 / 7, 8).
If the Endspan indicator (4) glows green, it means is that power is provided by endspan (1, 2 / 3, 6).
If the Midspan indicator (3) glows orange and at the same time the Endspan indicator (4) glows green, it means that the power is provided by
both midspan and endspan (1, 2, 3, 6 and 4, 5, 7, 8).
Midspan indicator
Orange
X
Orange
Specifications
Testing cable types
Wire mapping
Midspan/endspan identification
PoE test
Operating temperature range
Power supply
The manufacturer reserves the right to make changes to the product range and specifications without prior notice.
Care and maintenance
Do not use the device in a high voltage environment (e.g. 220V AC electric power supply). Do not use the device if it is not working
properly. Protect the device from sudden impact and excessive mechanical force. Store the device in a dry cool place. Please note that
the parameters of the power supply must comply with the technical characteristics of the device. Do not touch any bare conductor with
your hand or skin. Do not try to disassemble the device on your own for any reason. For repairs and cleaning of any kind, please contact
your local specialized service center. Only use accessories and spare parts for this device that comply with the technical specifications.
Never attempt to operate a damaged device or a device with damaged electrical parts! If a part of the device or battery is swallowed,
seek medical attention immediately.
Battery safety instructions
Always purchase the correct size and grade of battery most suitable for the intended use. Always replace the whole set of batteries at one
time; taking care not to mix old and new ones, or batteries of different types. Clean the battery contacts and also those of the device prior
to battery installation. Make sure the batteries are installed correctly with regard to polarity (+ and –). Remove batteries from equipment
that is not to be used for an extended period of time. Remove used batteries promptly. Never short-circuit batteries as this may lead to high
temperatures, leakage, or explosion. Never heat batteries in order to revive them. Do not disassemble batteries. Remember to switch off
devices after use. Keep batteries out of the reach of children, to avoid risk of ingestion, suffocation, or poisoning. Utilize used batteries as
prescribed by your country's laws.
Levenhuk International Warranty
Levenhuk products, except for their accessories, carry a 5-year warranty against defects in materials and workmanship. All Levenhuk
accessories are warranted to be free of defects in materials and workmanship for six months from the purchase date. The warranty entitles
you to the free repair or replacement of the Levenhuk product in any country where a Levenhuk office is located if all the warranty conditions
are met.
For further details, please visit: levenhuk.com/warranty
If warranty problems arise, or if you need assistance in using your product, contact the local Levenhuk branch.
Endspan indicator
x
Green
Green
STP/UTP (CAT5, CAT6) network cable, telephone cable
+
+
+
–10... +40°C / +14... 104°F
1pc 9V battery
4
Test result
Midspan (4, 5 / 7, 8)
Endspan (1, 2 / 3, 6)
4 pairs (1, 2, 3, 6 and 4, 5, 7, 8)