Publicidad
Idiomas disponibles
Idiomas disponibles
EMERGENCIES:
If a gas leak cannot be stopped, or a fire occurs due to gas leakage, call the fire department.
Sasleakingfrom
._racked/cut/burned hose.
Sasleakingfrom LP
._ylinder.
Sasleakingfrom LP
._ylinder valve.
SasleakingbetweenLP
._ylinder and regulator
._onnection.
Firecomingthrough
._ontrol panel.
Sreasefire or continuous
_xcessive flamesabove
._ooking s urface.
Troubleshooting
• Damagedhose.
• Mechanical f ailuredue to rustingor
mishandling.
• Failureof cylindervalvefrom mishandling
or mechanical f ailure.
• Improperinstallation, c onnectionnot
tight,failureof rubberseal.
• Fire in burnertubesectionof burnerdue
to blockage.
• Too muchgreasebuildupin burnerarea.
GASISSUES:
•Turnoff gas at LP cylinderor at sourceon naturalgassystems. If the
hoseis crackedor cut but notburned,simplyreplacevalve/ hose/
regulator.If the hose is burned,the causecouldbe otherthana
faultyvalve/hose/regulator. Discontinue use of grill untila plumberor
gastechnicianhasinvestigated and correctedthe problem.
• ReplaceLP cylinder.
• Turnoff LP cylindervalve.ReturnLP cylinderto gassupplier.
•Turnoff LP cylindervalve.Removeregulatorfrom cylinderand
visuallyinspectrubbersealfor damage.See LP CylinderLeakTest
and ConnectingRegulator to theLP Cylinder.
•Turnoff controlknobsand LP cylindervalve.Leavelid opento allow
flamesto die down.After fire is out and grill is cold, removeburner
and inspectfor spidernestsor rust.See SpiderAlertand Cleaning
the BurnerAssemblysectionsof this Use & CareGuide.
• Turnoff control knobsand LP cylindervalve.Leavelid open to allow
flamesto die down.After cooling,cleanfood particlesand excess
greasefrom insidefireboxarea,greasetray,and othersurfaces.
Burner(s)will not light
usingignitor.
(See ElectronicIgnition
Troubleshooting also)
Continued on next
page.
• Tryingto lightwrongburner.
• Burnernotengagedwith controlvalve.
• Obstructionin burner.
• No gasflow.
• Vaporlock at couplingnut to LP cylinder.
• Couplingnutand LPcylindervalve not
fully connected.
ELECTRICALISSUES:
• Electrodecrackedor broken;"sparksat
crack.
• Electrodetip not in properposition.
• Wireand/orelectrodecoveredwith
cookingresidue.
• Wiresare looseor disconnected.
• Wiresare shorting(sparking)between
ignitorand electrode.
• Deadbattery.
• See instructionson controlpaneland in Use and Caresection.
• Makesure valvesare positionedinsideof burnertubes.
• Ensureburnertubes are notobstructedwith spiderwebs or other
matter.Seecleaningsectionof Use and Care.
• Makesure LP cylinderis notempty. If LP cylinderis not empty,
referto "Suddendrop in gasflow."
• Turnoff knobsand disconnect c ouplingnutfrom LP cylinder.
Reconnect a nd retry.
• Turnthe couplingnutapproximately one-halfto three-quarters
additional t urn untilsolidstop.Tightenby handonly- do not use
tools.
• Replaceelectrode(s).
MainBurners:
• Tip of electrodeshouldbe pointingtowardgasportopeningon
burner.Thedistanceshouldbe 1/8"to 1/4".Adjust if necessary.
Sideburner
• Tip of electrodeshouldbe pointingtowardgasportopeningon
burner,the distanceshouldbe 1/8"to 3/16".Adjustif necessary.
• Cleanwireand/orelectrodewith rubbingalcoholand cleanswab.
• Reconnect w ires or replaceelectrode/wire assembly.
• Replaceignitorwire/electrode assembly.
• Replacewith a newAAA-sizealkalinebattery.
26,146.23676310
Publicidad
