Publicidad
Idiomas disponibles
Idiomas disponibles
flames from water heaters, electric
motors orswitches,
furnaces,
etc.
• Store u nit s oline limiter blade c annot
accidentally
cause injury. The unit
can behung b ythe tube.
• Store u nit o ut o freach ofchildren.
SAFETY NOTICE:
Exposure
tovibra-
tions t hrough prolonged
use ofgaso-
line powered hand t ools could c ause
blood v essel ornerve d amage inthe
fingers, hands, and joints o fpeople
prone t ocirculation
disorders
orab-
normal swellings.
Prolonged
use in
cold weather has been l inked t oblood
vessel damage inotherwise
healthy
people. Ifsymptoms
occur such as
numbness,
pain, loss ofstrength,
change inskin color o rtexture, orloss
offeeling inthe fingers, hands, or
joints, discontinue
theuse ofthis tool
and seek m edical attention.
Ananti-
vibration system d oes n ot g uarantee
the avoidance
ofthese p roblems.
Us-
ers who operate power tools o nacon-
tinual and regular basis m ust monitor
closely their p hysical condition and
the condition ofthis tool.
SPECIAL NOTICE: This unit i s
equipped with atemperature
limiting
muffler and spark a rresting
screen
which m eets the requirements
ofCali-
fornia C odes 4442 a nd 4443. AllU.S.
forest land and thestates ofCalifornia,
Idaho, Maine, Minnesota,
New Jersey,
Oregon, and Washington
require by
law that m any internal combustion
en-
gines b eequipped with aspark a rrest-
ing screen. Ifyou operate inalocale
where s uch regulations
exist, you are
legally responsible
formaintaining
the
operating condition
ofthese p arts.
Failure todosoisaviolation ofthe
law. For n ormal homeowner
use, the
muffler and spark a rresting
screen will
not r equire any service. After 50hours
ofuse, werecommend
that y our m uf-
fler beserviced orreplaced byyour
Sears S ervice Center.
CARTON
CONTENTS
Check carton c ontents against the fol-
lowing list.
Model 358.791010
• Trimmer
• Shield
• Container of Oil
Examine parts for damage.
Do not
use damaged
parts.
NOTE: If you need assistance
or find
parts missing or damaged,
call
1-800-235-5878.
It is normal for the fuel filter to rattle in
the empty fuel tank.
Finding fuel or oil residue on muffler is
normal due to carburetor
adjustments
and testing done by the manufacturer.
ASSEMBLY
,_WARNING:
If received
as-
sembled,
repeat all steps to ensure
your unit is properly assembled
and all
fasteners
are secure.
ADJUSTING
THE HANDLE
'_WARNING:
When adjusting tile
assist handle, be sure it remains above
the safety label and below the mark or
arrow on the shaft.
1. Loosen wing nut on handle.
2.
Rotate the handle on the shaft to an
upright position; retighten wing nut.
ATTACHING
SHIELD
_WARNING:
The shield must be
properly installed. The shield provides
partial protection from the risk of thrown
objects to the operator and others and
is equipped with a line limiter blade
which cuts excess line to the proper
length. The line limiter blade (on under-
side of shield) is sharp and can cut you.
For proper orientation of shield, see
KNOW YOUR TRIMMER illustration in OP-
ERATION section.
1. Remove wing nut from shield.
2.
Insert bracket into slot as shown.
3.
Pivot shield until bolt passes
through hole in bracket.
4.
Securely tighten wing nut onto
bolt.
Bracket
Slot
Wing Nut
PIVOT
Shield
Publicidad
