GET SX1 PRO 4T Guia página 12

4.
Twist the throttle
completely in open
position. While keeping
it open, press and hold
the engine stop button
for 5 seconds or until the
5 sec.
SX1 turns the fuel pump
on and the MIL light on.
By doing this operation,
the maximum TPS value
is saved.
5.
Wait for the Latch
1 2
Mode function to
deactivate. If a battery
was used in point 2,
disconnect its wires from
the "RESET TPS" cable,
starting from the black
wire (-) and then the red
wire (+).
6.
Unplug the RESET TPS
connector from SX1PRO
main connector and start
the engine.
EN
12