KYT KX-1 RACE Manual De Instrucciones página 33

PADDING — E — F — G —
The inner padding, can be easily removed to be washed or replaced.
EN
Inner central padding: INNER SHELL — E — Figure 7
Assembly and disassembly
The inner shell (E) is fixed to the helmet through 4 press studs (F).
Removing the inner padding
Snap to open the press studs (F) and remove the inner shell (E). Be very careful when removing the
shell, press on the rigid part of the stud and pull slightly towards the inside of the helmet without
damaging the press stud.
Caution: to avoid damages to the inner lining, before removing the inner shell make
sure that all the press studs have been unhooked.
Assembly
Insert the shell (E) inside the helmet checking the assembly direction. Fasten the press studs (F).
After fixing the inner shell, make sure the shell is correctly positioned inside the helmet (polystyrene
padding).
E
F F
FIGURE 7
F F
33