Global 292660 Manual Del Usuario página 3

Assembly/Installation
After unpacking the unit, carefully inspect contents for any loose,
missing, or damaged parts that may have occurred during transit.
Models: 292660, 292661 & 292662
COMPONENT PARTS
Cool air outlet hoses
Top fan exhaust flange
Display/Control board
Evaporator/filter
Condenser/filter
Guide bar for condensate water tank
Condensate water tank (Water level is sensed, and
the unit operation is stopped when tank is full. An
alarm will be displayed. Empty the tank and replace
to resume operation.
Figure 1
Font and Right Side View
POWER CORD HOLDER
1. Take out the cord holder from the accessory box.
2. Place the cord holder on the back side of air
conditioner.
3. Use screws (enclosed inside of accessory box
with cord holder) to install the cord holder on the
air conditioner as shown in Figure 2.
Figure 2
Figure 3
Back and Left Side View
TOP FAN EXHAUST FLANGE
1. Remove the top fan exhaust flange from carton.
2. Place the top fan exhaust flange on the top of air
conditioner.
3. Use screws (enclosed inside of box with the top
fan exhaust flange) to install the top fan exhaust
flange on air conditioner as shown in Figure 4.
Figure 4
Figure 5
Industrial Portable AC
Electrical access panel
Power cord holder
Caster
DISCHARGE DUCTS/SUPPLY AIR DUCT
1. Remove cool air outlet hose(s) from carton.
2. Place the cool air outlet hose(s) on the front
top of air conditioner.
3. Use screws enclosed inside of box with cool
air outlet hose(s) to install the cool air outlet
hose(s) on the air conditioner as shown in
Figure 5.
Models: 292663 292845 & 292846
COMPONENT PARTS
Cool air outlet hose
Top fan exhaust flange
Display/Control board
Evaporator/filter
Guide bar for condensate water tank
Condensate water tank (Water level is sensed,
and the unit operation is stopped when tank is
full). An alarm will be displayed. Empty the tank
Figure 1
and replace to resume operation. (Except model
292846, Drain pump included).
Figure 2
POWER CORD HOLDER
1. Take out the cord holder from the accessory box.
2. Place the cord holder on the back side of air
conditioner.
3. Use screws (enclosed inside of accessory box
with cord holder) to install the cord holder on the
Figure 3
air conditioner as shown in Figure 3.
TOP FAN EXHAUST FLANGE
1. Remove the top fan exhaust flange from carton.
2. Place the top fan exhaust flange on the top of
3. Use screws (enclosed inside of box with the
Figure 4
Figure 5
NOTE: Condensate tank must be emptied regularly.
NOTE: Hot Air exhaust Duct can be purchased separately
3
User's Manual
Condenser/filter
Electrical access panel
Power cord holder
Caster
air conditioner.
top fan exhaust flange) to install the top fan
exhaust flange on air conditioner as shown in
Figure 4.
DISCHARGE DUCTS/SUPPLY
AIR DUCT
1. Remove cool air outlet hose(s)
from carton.
2. Place the cool air outlet hose(s) on
the front top of air conditioner.
3. Use screws enclosed inside of box
with cool air outlet hose(s) to install
the cool air outlet hose(s) on the air
conditioner as shown in Figure 5.