Sylvania LC260SC8 Manual Del Propietário página 21

O
PTIONAL SETTING
Channel List
The channel list function lets you remove undesired channels from the
channel registration list.
1
Press [SETUP] to display the main menu.
2
Use [Cursor K / L] to select "CHANNEL", then press
[ENTER].
3
Use [Cursor K / L] to select "Channel List", then press
[ENTER].
4
Use [Cursor K / L] to select the channel you want to
remove, then press [ENTER].
• The channel display for the removed channel
darkens. You will not be able to select the channel
again using [CH K / L].
• To reactivate a removed channel, highlight it using
[Cursor K / L] and press [ENTER]. The channel
display lightens.
• When you remove a major channel, its minor
channels are removed as well.
Note:
• The channel with the "DTV" indicated on the display is
ATSC. Otherwise the channel is NTSC.
5
Press [SETUP] to exit.
The manual register function lets you add the channels that were not added
by the auto channel scan due to the reception condition at the initial setting.
1
2
3
Channel Channel
Autoscan
Channel List
Manual Register
Antenna
4
Channel List
Channel List
Highlight channels for
DTV 6
DTV 6
Ch Up/Down key selection.
27
DTV 8
DTV 8
9 9
DTV DTV 48 48
58 58
DTV 67
BACK
Ch Select ENTER Watch/Skip Back
5
Manual Register
Press [SETUP] to display the main menu.
Use [Cursor K / L] to select "CHANNEL", then press
[ENTER].
Use [Cursor K / L] to select "Manual Register", then
press [ENTER].
Use [the Number buttons] to enter the number of the
channel you want to add, then press [ENTER].
Press [SETUP] to exit.
Note:
• If set up completes successfully,
"Registered to the Channel List" is displayed.
• If external input is used, it is not possible to register the
channel and "Unavailable" will be displayed on the TV
screen.
Channel Channel
Autoscan
Channel List
Manual Register
Antenna
11
Manual Register Manual Register
Register
For analog channels,
select a channel to register using
number keys.
For digital channels,
you must perform Autoscan function.
BACK
Back
Ch Change
21
EN