Triton Blue TR-FULL48 Manual De Usuario página 7

INTRODUCTION
i
The Triton Blue TR-FULL48 control is used in installations where a DMX signal is required for product tests,
showrooms or manual control of DMX projectors and a large control or table with hundreds of preparations,
libraries or complex programming is not necessary. For these occasions the TR-FULL48 is the economic and
easy to control control providing the best solution. It is so simple that you only need to raise potentiometers
to get the result.
PACKAGE
In the box are included:
1 x 48-channel DMX control table TR-FULL48
1 x AC to DC Adapter
1 x User Manual
Carefully unwrap the package, check the contents to ensure that all items are present and received in good
condition. If any parts are missing or damaged, contact your supplier immediately and retain the packaging
material for inspection.
SAFETY INSTRUCTIONS
This device has left our premises in absolutely perfect condition. In order to maintain this condition and to ensure a safe
operation, it is absolutely necessary for the user to follow the safety instructions and warning notes written in this manual.
• The manufacturer will not accept liability for any resulting damages caused by the non-observance
of this manual or any unauthorized modification to the device.
• Please consider that damages caused by manual modifications to the device are not subject to
warranty.
• During the operation the housing becomes hot). Allow the fixture to cool approximately 10 minutes
prior to manipulate with it.
• Make sure that the available voltage is not higher than stated on the rear panel.
• WARNING! This unit does not contain an ON/OFF switch. Always disconnect power input cable to
completely remove power from unit when not in use or before cleaning or servicing the fixture.
• Make sure that the power-cord is never crimped or damaged by sharp edges. Check the device and
the power-cord from time to time.
• Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle
the power-cord by the plug. Never pull out the plug by tugging the power cord.
• The electric connection, repairs and servicing must be carried out by a qualified employee.
• Do not switch the fixture on and off in short intervals as this would reduce the lamp's life.
• During the initial start-up some smoke or smell may arise. This is a normal process and does not
necessarily mean that the device is defective.
ENGLISH
User Manual | TR-FULL48 by Triton Blue | For Professinal use only, not for residential use
7.