Triton Blue TR-DMX48-2 Manual De Usuario página 19

IMPORTANT: Always remember to exit Record mode when you won't continue your programming, otherwise you may
NOTA: The second time you enter your new Record Code different from that of the first time, the LEDs will not flash, which
means you've failed to change the Record Code. When you enter a new Record Code the first time, provided that you want
to cancel the new Record Code, press and hold down the Record and Exit buttons at a time to exit
1.3 Program Scenes
1) Record Enable.
2) Select the 1-48 Single mode by tapping the Mode Select button. This will give you control of all 48 channels
as you program
Be sure that Master A & B are both set at maximum. (Master A is at its maximum when positioned all the way
up, while Master B is at its maximum when positioned all the way down.)
3) Create a desired scene using Channel Sliders 1-48. At 0% or DMX 255, these sliders should be at 10 position
4) Once the scene is satisfactory, tap the Record button to program the scene as a step into the memory
5) Repeat step 3 and 4 until all desired steps have been programmed into memory. You may program up to
1000 steps into memory
6) Select a chase bank or scene master to store your program. Tap the Page button select a page (Page 1-4) to
store your scenes
7) Press a Flash button between 25-48 while holding down the Record button. All LED will flash indicating the
scenes have been programmed into memory
8) You can continue programming or exit. To exit Program mode, tap the Exit button while holding down the
Record LED should go out
EXAMPLE: Program a 16 steps chase with channel 1-32 at full in sequence and assign into Flash button 25 of Page 1
2.- EDITING
2.1 Edit Enable
1) Record enable
2) Use the Page button to select the page the program you wish to edit is on
3) Tap the Mode Select button to select CHASE
4) Press and hold down the Edit button
5) While holding down the Edit button, tap the Flash button that corresponds to program you wish to edit
6) Release the Edit button, the relevant scene LED should light indicating you are in the Edit mode
2.2 Erase a Program
1) Record enable.
2) Use the Page button to select the page that the program you wish to erase is on
3) While holding down the Edit button, tap the Flash button (25-48) twice
4) Release the two buttons, all LEDs flash, indicating the program is erased
2.3 Erase All Programs
1) Press and hold the Record button
2) Tap the Flash buttons 1, 4, 2 and 3 in sequence while holding the Record button. All LED will flash, indicating
all programs stored in memory have been erased
2.4 Clear a Scene or Scenes
1) Record enable
2) Record a scene or scenes
lose control of your unit
User Manual | TR-DMX48-2 by Triton Blue | For Professinal use only, not for residential use
SCENES
19.