SETTING
1.- Mounting
The Moving Head is fully operational in any mounting position, hanging upside-down, side mounted, or set on a
flat llevel surface, etc.
IMPORTANT: Safety cables must always be used when unit is celling or truss mounted. The safety cable must be capable of
holding 10 times the weight of the fixture.
2.- AC Power
1) The fixture is designed to work on AC 90-240V 50-60Hz. All units must be powered directly from a switched
circuit. This unit cannot be run on a rheostat or dimmer circuit even if used solely for a 0% to 100% switching.
WARNING: All fixtures must be connected to circuits with a suitable Earth Ground.
Mapa menu
User Manual | Q-BEAM200 by Triton Blue | For Professinal use only, not for residential use
Set DMX address and select DMX
channel mode
Select running mode
Display setting
Scene editing
Advanced setting
15.