GreenWorks 48T16 Manual Del Operador página 10

EN
10.3 REPLACE THE SPOOL
1. Push the tabs (19) on the sides of the trimmer head at the
same time.
2. Pull and remove the spool cover (17).
3. Remove the remaining spool (18).
4. Put the new spool in the spool cover.
Make sure that the cutting line is in the slot on the new
spool, and is extended approximately 15 cm before you
install the new spool.
5. Put the ends of the cutting lines through the holes (20).
6. Extend the cutting line to release it from the guide slot in
the spool.
NOTE
English
7. Install the spool and spool cover onto the trimmer head.
8. Push the spool cover until it clicks into position.
10.4 REPLACE THE CUTTING LINE
Remove the remaining cutting line on the spool.
Use only with the nylon cutting line of .08" (2 mm)
diameter.
1. Cut a piece of cutting line approximately 3m long.
2. Bend the line at the midpoint and hook the loop into the
slot in the center rim of the spool. Make sure that the line
snaps into position in the slot.
3. With your finger between the lines, wind the lines equally
and tightly around the spool in the indicated direction.
4. Put the lines in the guide slots.
10
NOTE
NOTE