Triton Blue WDMX-TR512 Manual De Usuario página 8

Setting up the transceiver in receiver mode
• Keep the (ID) button (nº4) pushed in while powering up the TRANSCEIVER. The status LED (nº2) will
become WHITE color shortly, tham turs BLUE or GREEN (the last selected mode)
• Choose GREEN by pushing the (ID) button (nº4) shortly
• Once GREEN selected, push the (ID) button (nº4) for 3 seconds to confirm the transmitter mode
• The status LED will turn WHITE and after a few seconds turns RED (brinking if there is no DMX signal
present)
• The unit is now in receiver mode
Connecting one or several receivers to a transmitter. To connect your receiver or receivers to a specific transmitter:
• 1.- Make sure that the receivers to be connected are not linked to another transmitter: the status LED
(nº2) on these receivers should be WHITE
• 2.- Press the (ID) button (nº4) of the transmitter shortly: the status LED (nº3) on both the transmitter
(BLUE color) and recesivers (RED color) starts blinking
• 3.- Wait until blinking stops: the receivers are now linked to transmitter
• 4.- Check if the connection was made properly: press the (ID) button (nº4) on the transmitter again,
the status LED (nº2) on all linked receivers star blinking. Receivers linked to another transmitter will
not blink
Disconnecting receivers from a DMX universe. To disconnected all the receivers from a DMX universe/transmitter:
• 1.-Press the (ID) button (nº4) of the transmitter for about 5 seconds until the status LED (nº2) turns
RED, the status LED on the receivers turns WHITE (disconnected) for a second, than turns RED (no
signal present)
• After a few moments the status LED (nº2) on the transmitter turns BLUE again
• Note: To disconnect an individual receiver from a DMX universe/transmitter: Press the (ID) buttn (nº4)
of the receiver for about 5 seconds until the status LED (nº2) turns WHITE color. This receiver is now
disconnected from the transmitter (DMX universe)
8.
User Manual | WDMX-TR512 by Triton Blue | June 2023 | www.triton-blue.com