Craftsman 152.211240 Manual Del Propietário página 9

EYE SHIELDS (Fig. G)
1 Remove both Eye Shield Assemblies from the
plastic bags and check to see that you have the
following:
Eyeshield (2)
Lock Knob (2)
Spacer (2)
M6 Flat washer (2)
M6 x 80ram carriage head screw (2)
2. Assemble the eyeshield (C) to the Spark Arrestor
(A) inserting carriage head screw (B) through
Eyeshield, the Spark Arrestor, and the Spacer (D)
as shown. See Figure G.
3_
Assemble the flat washer (E) and Lock Knob (F)
to the carriage head screw and tighten until the
Eyeshieid remains in the desired position..
See Figure G.
CAUTION: The Flexible Work Light housing will remain
hot for a few minutes after turning it "OFF".. Avoid con-
tact with housing until it is cool.
Fig, J
A
\ ,B
Fig. G
E
D B
C
PERMANENT MOUNTING (Fig. K)
You should firmly attach the Bench Grinder to a sotid
work s[Jrface, hardware not inc_udedo
Fig. K
A
WORK LIGHT (Fig. J)
The Bench Grinder is provided with a Flexible Work
Light to assist in visibility of the workpiece..
'The Bench Grinder is NOT provided with a tight bulb for
the Flexible Work Light.
\f
\
\
®
®
To reduce the risk of fire, use a 120 volt, 40 Watt or tess
Track Light Bulb, Type R20, medium base or equivalent
(not included). DO NOT use a light bulb that extends
past the end of the light housing.
The Ftexible Work Light may be turned "ON" or "OFF"
by using the rotary switch (B) on the top surface of the
housing (A)., The switch can be rotated in the clockwise
direction only. See Figure J,.
NOTE: The Flexible Work Light can be tumed "ON" or
"OFF" even if the Bench Grinder is turned "OFF"°
9
If the Bench Grinder is not securely mounted, it will
have the ability to move or tip over during grinding
operations and possibly cause the operator's fingers to
contact the grinding wheels..