Cloer 6080 Instrucciones De Uso página 8

Technical Data
type volt
608 220-240
609 230
Before the first use
Read these operating instructions
carefully before using the appliance
for the first time.
EN
• Remove all packing parts and possibly stickers, but
not the serial number.
• Place the egg boiler on a dry, non-slip and level surfa-
ce before the first use
• Clean the surface of the heating bowl, the hood and
the egg tray with a damp cloth.
Safety notes for using the egg boiler
The device corresponds to
the requirements of the
applicable EC guidelines.
The device is exclusively intended
for use in closed rooms.
ATTENTION! Pull out the power plug
when not in use and before each
cleaning!
• Fill in cold water only.
• When filling in the water quantity keep to the mar-
king on the measuring cup.
• Attention! During the boiling process hot steam
escapes out of the lid.
• Do not switch on the appliance if no water is filled in.
• Do not fill in more water than MAX, with the maxi-
mum water quantity marked on the measuring cup
by the marking „1 hard ".
The water quantities on the measuring cup are
guide numbers, smaller variances can occur be-
cause of size, age and temperature of the eggs.
• Attention! There is a sharp spike at the underside
of the measuring cup which serves as the egg pick.
• Avoid injuries from egg picker.
• Decalcify the appliance regularly (s. cleaning / decal-
cification).
Starting-up
• In this egg boiler you can boil one to six eggs at the
same time.
• Remove the cover from the appliance.
8
hz watt
50 350
50 400
Attention
• You can choose between soft, medium and hard eggs.
• Ascertain the water quantity depending on the num-
ber of eggs and the requested hardness.
• You can ascertain this by means of the filling quantity
marking on the measuring cup.
• Fill the appliance with the measured water quantity.
• See to it that the maximum water quantity thereby is
not exceeded as otherwise the water is likely to boil
over. Danger of burn!
• To avoid the eggs splitting during boiling, prick the
eggs by means of the egg pick which you can find at
the underside of the measuring cup.
• Put eggs on the egg carrier.
• Set lid on appliance.
• Put power plug in power socket.
• Now switch on „Cook" or „Cook" with audible signals.
• The control lamp lights up.
• If you set on „Cook" there does not appear a signal at
the end. If the water is evaporated, the eggs are ready.
• If you set on „Cook" with audible signals, an audible
signal appears once the eggs are ready.
• Now turn the regulator on „Off".
• The control lamp lights off.
• Pull the power plug.
• Remove lid carefully. To do so, take the cover at the
right and left handle.
• Take the eggs out of the appliance and run the eggs
under cold water.
Poaching eggs
Precondition is an appliance with inserts for poa-
ched eggs (not contained in every model).
• Put egg carrier on the appliance.
• You can choose between simply poached or poached
eggs with toppings (e.g. bacon).
• Ascertain the water quantity based on the symbols of
the measuring cup.
• Fill the appliance with the measured water quantity.
• See to it that the maximum water quantity is not ex-
ceeded as otherwise the water is likely to boil over.
Danger of burn!
• Grease the inserts with a little oil so that the eggs do
not stick.
• Now put the inserts for poaching the eggs on the egg
carrier.
• Beat respectively one egg at the most in the inserts.
• Put the power plug in the power socket and continue
as described under starting-up.
• The eggs need not be run under cold water at the
end any more.