Publicidad
Idiomas disponibles
Idiomas disponibles
GENERAL
RECOMMEN
DATIONS
The warranty on this unit does not
cover items that have been subjected
to operator
abuse or negligence.
To
receive full value from the warranty,
the operator
must maintain
unit as
instructed
in this manual. Various ad-
justments
will need to be made peri-
odically to properly maintain
your unit.
CHECK
FOR LOOSE
FASTENERS
AND PARTS
• Spark Plug Boot
• Air Filter
• Housing Screws
• Assist Handle Screw
• Debris Shield
CHECK
FOR DAMAGED
OR
WORN PARTS
Contact Sears Service
Center for re-
placement
of damaged
or worn parts.
• ON/OFF Switch - Ensure ON/OFF
switch functions
properly
by moving
the switch to the OFF position.
Make
sure engine stops; then restart en-
gine and continue.
• Fuel Tank - Discontinue
use of unit
if fuel tank shows signs of damage
or leaks.
• Debris Shield - Discontinue
use of
unit if debris shield is damaged.
INSPECT
AND CLEAN
UNIT AND
DECALS
• After each use, inspect complete
unit for loose or damaged
parts.
Clean the unit and decals using a
damp cloth with a mild detergent.
• Wipe off unit with a clean dry cloth.
CLEAN
AIR FILTER
A dirty air filter decreases
engine per-
formance
and increases fuel con-
sumption
and harmful emissions.
Al-
ways clean after every 5 hours of
operation.
1. Clean the cover and the area
around it to keep dirt from falling
into the carburetor
chamber
when
the cover is removed.
2.
Remove parts by pressing
button
to release air filter cover.
NOTE:
To avoid creating a fire hazard
or producing
harmful evaporative
emissions,
do not clean filter in gaso-
line or other flammable
solvent.
3.
Wash the filter in soap and water.
4.
Allow filter to dry.
5.
Replace parts.
j_
Air Filter
Button
fJ.,_,'7". _.
_.
_e -_j_
_ ,y_-,_
Air Filter
INSPECT
MUFFLER
AND SPARK
ARRESTING
SCREEN
_IWARNING:
The muffler on this
product contains chemicals known to
the State of California to cause cancer.
As your unit is used, carbon deposits
build up on the muffler and spark ar-
resting screen.
For normal homeowner
use, however,
the muffler and spark arresting screen
will not require any service.
After 50
hours of use, we recommend that your
muffler be serviced or replaced by your
Sears Service Center.
REPLACE
SPARK PLUG
Replace the spark plug each year to
ensure the engine starts easier and
runs better. Set spark plug gap at
0.025 inch. Ignition timing is fixed and
nonadjustable.
1. Twist, then pull off spark plug boot.
2.
Remove spark plug from cylinder
and discard.
3.
Replace with Champion
RCJ-6Y
spark plug and tighten securely
with a 3/4 inch socket wrench.
4.
Reinstall the spark plug boot.
14
Publicidad
