Descargar Imprimir esta página

Craftsman 917.388280 Manual Del Propietário página 13

Publicidad

Idiomas disponibles

Idiomas disponibles

° Clean the inside of the cover and the
collar to remove any dirt accumulation.
• Insert new filter into cover.
• Put air filter cover and filter into collar
aligning the tab with the slot.
• Push in on cover and turn clockwise to
tighten.
Collar
Clip
Slot
Air filter
Turn
counter--
clockwise to
remove
clockwise
Air filter cover
to tighten
MUFFLER
Inspect and replace corroded muffler as it
could create afire hazard and/or damage,
SPARK PLUG
Change your spark plug each year to
make your engine start easier and run
better. Set spark plug gap at ,030 inch°
CLEANING
IMPORTANT:
For best performance,
keep
mower
housing free of built--up
grass
and trash. Clean
underside
of mower
housing
after each use.
_,CAUTION:
Disconnect spark plug wire
from spark plug and place wire whereit cannot
come in contact with the spark plug.
• Turn lawn mower on its side. Make sure
air filter and carburetor are up. Clean
the underside of your lawn mower by
scraping to remove build--up
of grass
and trash.
• Clean engine often to keep trash from
accumulating. A clogged engine runs
hotter and shortens engine life.
• Keep finished surfaces and wheels free
of all gasoline, oil, etco
• We DO NOT recommend using a
garden hose to clean lawn mower
unless the electrical system, muffler, air
filter and carburetor are covered to
keep water ouL Water in engine can
result in shortened engine life_
_tb.CAUTION:
Before
performing
any
service
or adjustments:
• Release
control
bar and stop engine.
• Make sure the blade and all moving
parts have completely
stopped.
• Disconnect
spark
plug wire from spark
plug and place where
it cannot
come in
contact with plug.
LAWN MOWER
TO ADJUST
CUTTING
HEIGHT
See "TO ADJUST
CUTTING
HEIGHT"
in
the Operation section of this manual.
REAR DEFLECTOR
The rear deflector, attached
between
the
rear wheels of your lawn mower,
is
provided
to minimize
the possibility
that
objects
will be thrown
out the rear of the
lawn mower
into the operator's
mowing
position_
If the rear deflector becomes
damaged,
it
should be replaced°
TO ADJ UST HAN DLE
The handle can be mounted in a high or
low position. The mounting holes in the
bottom of lower handle are off center for
raising or lowering the handle,
• Remove upper handle and all parts
attached to lower handle,
° Remove hairpin cotters from lower
handle bracket mounting pin°
• Squeeze lower handle in to remove it
from mounting pins.
• Turn lower handle over to raise or lower
handle.
• Squeeze lower handle in and position
holes onto mounting pins on handle
bracket.
• Reassemble upper handle and all parts
removed from lower handle.
Rotate
Lower
handle
13

Publicidad

loading