Publicidad
Idiomas disponibles
Idiomas disponibles
GRASS
CATCHER
• The grass catcher
may be hosed with
water, but must be dry when used.
• Check
your grass catcher
often for
damage
or deterioration.
Through
normal use it will wear.
If catcher
needs
replacing,
replace
only with a
manufacturer
approved
replacement
catcher.
Give the lawn mower
model
number
when
ordering.
DRIVE WHEELS
Check
front drive wheels each time
before you mow to be sure they move
freely.
The wheels not turning freely means
trash, grass cuttings, etc. are in the drive
wheel area and must be cleaned
to free
drive wheels.
If necessary
to clean the drive wheels,
check both front wheels.
1.
Remove
hubcaps, hairpin cotters and
washers.
2.
Remove
wheels from wheel adjusters.
3.
Remove any trash or grass cuttings
from inside the dust cover, pinion and/
or drive wheel gear teeth.
4.
Put wheels back in place.
NOTE:
If after cleaning, the drive wheels
do not turn freety, contact a Sears
or other
qualified service center.
GEAR CASE
• To keep your drive system working
properly, the gear case and area
around the drive should be kept clean
and free of trash build-up. Clean under
the drive cover twice a season.
• The gear case is filled with lubricant to
the proper level at the factory. The only
time the lubricant needs attention is if
service has been performed on the
gear case.
• If lubricant is required, use only Texaco
Starplex Premium 1 Grease, Part No.
750369.
Do not substitute.
ENGINE
LUBRICATION
Use only high quality detergent
oil rated
with API service classification
SF-SJ.
Select the oil's SAE viscosity grade
according
to your expected
operating
temperature.
SAE VISCOSITY
GRADES
-20
0
30
32
40
60
80
TEMPERA"[_RE
RANGE ANTICIPATED
BEFORE NEXT OIL CHANGE
NOTE:
Although
multi-viscosity
oils
(5W30,
10W30
etc.) improve
starting
in
cold weather,
these multi-viscosity
oils
will result in increased
oil consumption
when used above 32°F. Check your
engine oil level more frequently
to avoid
possible
engine damage
from running
low on oil.
Change the oil after every 25 hours of
operation or at least once a year if the
lawn mower is not used for 25 hours in
one year.
Check
the crankcase
oil level before
starting the engine and after each five (5)
hours of continuous
use. -I]ghten oil plug
securely each time you check the oil
level.
TO CHANGE ENGINE OIL
NOTE: Before tipping lawn mower to
drain oil, drain fuel tank by running
engine until fuel tank is empty.
1. Disconnect spark plug wire from spark
plug and place wire where it cannot
come in contact with spark plug.
2. Remove engine oil cap; lay aside on a
clean surface.
3. Tip lawn mower on its side as shown
and drain oil into a suitable container.
Rock lawn mower back and forth to
remove any oil trapped inside of
engine.
4. Wipe off any spilled oil from lawn
mower or side of engine.
5. Fill engine with oil. (See "ADD OIL" in
the Operation section of this manual.)
6. Reconnect spark plug wire to spark
plug.
12
Publicidad
