Descargar Imprimir esta página

Greencut JET-3200 Manual De Instrucciones página 37

Ocultar thumbs Ver también para JET-3200:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

BOX CONTENTS
1.
Pressure washer
2.
Floor cleaning accessory
3.
Brushes (2x)
4.
Attachment for 360º spraying
5.
Outlet nozzles (5x)
6.
Pistol
7.
User's manual
Remove the product and accessories from the box. Make sure all items are present.
Inspect the product to ensure that it has not been broken or damaged in transit.
Do not discard the packaging material until you have carefully inspected and satisfactorily used the product.
ATTENTION: If any part is missing or damaged, please contact the Official Technical Service. Do not
use this product without replacing the part. Using this product with damaged or missing parts can
cause serious injury to the operator.
IGNITED
1.
Connect the water supply hose to the appliance and connect the gun to the outlet hose.
2.
Connect the nozzle and nozzle extension.
3.
Check that the filter is free of clogging.
4.
Connect the water supply hose.
5.
Check that the hose is not bent.
6.
Turn on the water and check for leaks.
7.
Push the trigger to release air from the pump and hose and then lock the trigger.
8.
Plug the appliance in and turn the switch to the ON position.
9.
Unlock the trigger and use the pressure washer.
ATTENTION: It is important to bleed the gun before using the pressure washer. Pull the trigger to
release any air trapped inside the appliance and hose. Continue to squeeze the trigger until a steady
stream emerges from the nozzle.
SWITCHING OFF
1.
Stop the engine by moving the switch to the OFF position.
2.
Unplug the device from the power supply.
3.
Turn off the water supply.
4.
Press the gun trigger to depressurize the system.
5.
Disconnect the water supply hose from the pressure washer.
6.
Wipe all surfaces of the unit with a clean, damp cloth.
2
1
7
3
4
6
5
37
EN

Publicidad

loading