Publicidad
Idiomas disponibles
Idiomas disponibles
Electrical safety
This tool is double insulated; therefore no earth wire is required. Always
check that the power supply corresponds to the voltage on the rating plate.
Assembly
Warning! Before assembly, make sure that the tool is switched off and unplug.
Use
Mounting The Nozzle For Blowing Operations (Fig. A)
Insert the pin located inside the Nozzle into the notch provided on the Blast Port
(1).
To lock Nozzle in place, turn the Nozzle in the direction indicated.
To remove Nozzle, turn the Nozzle in the opposite direction.
Mounting The Nozzle And Dust For Dust Collection (fig. B)
For dust collection, mount the Dust Bag at the Blast Port (2) and Nozzle at the
suction Port (6).
To remove Dust Beg and Nozzle, simply pull out by first turning in the opposite
direction.
Empty the Dust Bag frequently to ensure maximum dust collecting efficiency.
Adjust Variable Speed Knob (4) for different speed requirement.
When continuous operation is required, first depress the switch and then the
lock-on button (5) and release to disengage lock, squeeze and release switch.
Warning: Continuous running of machine should not exceed 30 minutes.
Replacing Carbon Brushes (fig. D)
Use a screwdriver to remove the brush holder cap.
Take out the worn carbon brush, insert the new one and secure the brush hold
cap.
Warning! Remove and check the carbon brushes regularly. Replace when they wear
down to the limit mark.
16
Publicidad
