Publicidad
Idiomas disponibles
Idiomas disponibles
English
speakers and the other end to the Speaker Output Terminals. To do this, flip the spring
clips to the open position, insert the speaker wire, and flip the spring clips to the closed
position. Set the Phono/Line Switch to Line setting.
Turntable Operation
1. Press the Power Switch to turn on the power.
2. Press the Mode Button and select the Phono mode.
Note: The Function Indicator will be red
3. Set the Speed Switch accordingly.
4. Place the record on the turntable. Use the 45 RPM Adapter if necessary.
5. Remove the stylus protector from the stylus assembly.
Note: To avoid stylus damage, make certain the included stylus guard is in place whenever
the turntable is being moved or cleaned.
6. Release the Tonearm Clip.
Note: when the turntable is not in use, remember to lock the Tonearm clip.
7. Use the Cue Lever to lift the tonearm.
8. Gently move the tonearm over the record where play is desired to begin. Set the
Cue Lever back to the down position. The tonearm will descend slowly onto the
record and begin to playback.
9. When the record is finished playing, use the Cue Lever again to raise the tonearm
and then return it to the Tonearm Rest. Release the lever to let the tonearm sit
back at its rest. To suspend the playback, repeat the same steps.
10. Lock the Tonearm Clip to secure the tonearm.
Anti-skate Adjustment
• A small outward "anti-skating" force can be applied to the tone arm to compensate
for the "skating" force that pulls the arm toward the center of the record.
• For best performance during normal turntable usage, it is recommended to set the
anti-skate control knob to the same value as indicated by the downforce scale dial.
Cartridge Replacement
1. Before replacement, put the stylus protector back on the stylus to prevent damage
to the stylus during the replacement process.
2. Carefully remove the wire leads from the original cartridge.
3. Loosen the two screws on the headshell that are securing the cartridge and then
remove the original cartridge.
4. Mount the new cartridge to the headshell and tighten it lightly. Do not completely
tighten the screws at this moment.
8
Publicidad
