Audibax IEW 600 Manual De Usuario página 8

IEW 600
AUTOMATIC RECEIVER SYNC
STEREO
Press the Sync button on the Emitter and point the receiving beltpack at the Sync Button
on the transmitter, make sure to place the receiving beltpack with the antenna pointing
at the receiver to improve synchrony, after a few seconds the receiving beltpack will mark
the frequency and channel displayed on the front display of the transmitter.
PARAMETER
Transmitting host parameters:
Frequency: 645-670MHZ
Frequency response: 50Hz - 15KHz
Power supply: 12V/500mA
Transmit power: High 30mW, Low 18mW
Receiver parameters:
Frequency: 645-670MHz
Modulation mode: UHF
Frequency response: 50Hz - 15KHz
Signal source sensitivity: - 104 dbm
Monitor output level:3.52mV
Distortion: <1%
Signal-to-noise ratio: 90 dB
Operating voltage: 3V
Working intensity: 120mA
www.audibax.com 6