Publicidad
Idiomas disponibles
Idiomas disponibles
BLOCK RELEASE GEAR BOX
This hedge trimmer is equipped with a block release system. If the blade jams, the blades will
automatically retract allowing the jam to be cleared easily. Release the triggers, remove jammed
material, then squeeze trigger again to restart the hedge trimmer. If the stem is too dense or too hard
to be trimmed, use a pruning saw to clear the stem.
OPERATING TIPS
Do not force the hedge trimmer through heavy shrubbery. This can cause the blades to bind and slow
down. If the blades slow down, reduce the pace.
Do not try to cut stems or twigs that are larger than 20mm thick, or those obviously too large to feed
into the cutting blade. Use a non-powered hand saw or pruning saw to trim large stems.
If desired, you can use a string to help cut your hedge level. Decide how high you want the hedge.
Then stretch a piece of string along the hedge at this height. Trim the hedge just above this guide line
of string. Trim the side of a hedge so that it will be slightly narrower at the top. More of the edge will
be exposed when shaped this way, and it will be more uniform. If blades do become jammed, stop
the motor, allow the blades to stop and remove the battery pack before attempting to remove the
obstruction.
Wear gloves when trimming thorny or prickly growth. When trimming new growth, use a wide
sweeping action, so that the stems are fed directly into the cutting blade. Older growth will have
thicker stems and will be trimmed easiest by using a sawing movement.
WARNING
IF blade jams on any electrical cord or line. DO NOT TOUCH THE BLADE! IT CAN
BECOME ELECTRICALLY LIVE AND VERY DANGEROUS.
Continue to hold the hedge trimmer by the insulated rear handle or lay it down and away from you
in a safe manner. Disconnect the electrical service to the damaged line or cord before attempting to
free the blade from the line or cord. Failure to follow this warning will result in serious personal injury
or possible death.
83
EN
Publicidad
