CARE FITNESS MED-710 Manual Del Usuario página 10

GB
Assembly Instruction
Please make sure there's enough space to install the treadmill and recommend 2 persons to install it.
WARNING: Don't insert the power wire until the treadmill was fully assembled.
1. Assembling left upright tube and Base frame
Take the treadmill out from the carton and lay it down on floor.Pull the
Signal wire (9) from the end of Right upright tube (5) to the top.
Install the Left/Right upright tube (4/5) to base frame (13) using eight
sets Half-round bolt M8X16 (A2), Flat washers φ8 （C1）. Do not tighten
all parts provisionally (See figure 1)