automatically only if the room temperature falls below 42°F, to prevent freezing con-
ditions.
Note: This function is not guaranteed in the event of power failures, lasting more
than 2 minutes.
TIMER OPERATION
The timer allows you to set two programs in a 24-hour period.
To program the timer:
Press the Timer button A (see Figure 2), the following is displayed:
-
The flashing message "--:--";
-
The message "ON" at the bottom left (ON time setting);
-
The symbol "A" at the right indicating that the first program controlling is being set;
To set the "START" time press the "hour button" to set the hour and "min button" to set
the minutes, then confirm the "START" time by pressing the "Timer button A" again.
The words "OFF" and "00:00" appear on the display.
Set the time you want the appliance to go OFF using the "hour button" and "min but-
ton", then confirm the OFF time by pressing the "Timer Function A" button again.
At this point, the word "AUTO" appears at the top of the display and the "TIMER
ON" indicator light comes on to indicate that the appliance is ready to operate
at the programmed time maintaining the preset comfort temperature (fig.2).
-
To set the program B press "Timer button B" and follow the same procedure as described
for the program A.
-
Use the " +" or "
as described above.
-
When set in this way the heater will automatically switch on at the set
time for the designated time period and automatically maintain the pre-
set comfort temperature.
To cancel a preset program, press the timer button A or B once and then press the hour but-
ton until the display shows "--:--" (fig. 3).
TIMER OVERRIDE
To operate the appliance without using the programs (timer), press the "ON MODE" button
(Fig.5). The yellow lamp will go off.
IMPORTANT:
If the heater looses its electricity supply for more than 2 minutes the appliance does not switch
on. The display shows the blinking numbers.
EW 7507 EK
EW 7507 EK
-" buttons to set the desired comfort temperature,
AUTO
:
¡F
fig. 2
AUTO
:
fig. 3
5