Panasonic CS-ME7DKDG Instrucciones De Funcionamiento página 7

HOW TO OPERATE
Auto, Heat, Cool, Dr y
���
����
�����
����
����
���
���
��� ��
����� �����
OFF/ON
MODE
FAN SPEED
POWERFUL AUTO
AIR SWING
QUIET
MANUAL
TIMER
ON SET
1 2 3
OFF CANCEL
CHECK CLOCK RESET
INVERTER
For DT, DD, DB-series
indoor unit
● For DK-series indoor unit, supersonic air purifying device
(super alleru-buster) operates automatically while the air
conditioner is switched on.
● Powerful and Quiet operations could be activated in all
operation modes.
OFF/ON
● Press /
OFF/ON
Hint
Heat is obtained from outdoor air to warm up the room. Use additional heater when outdoor ambient temperature is low.
●
Troubleshooting
Power indicator blinks.
●
Operation delayed for few minutes after restart.
●
Sounds like water flowing during operation.
●
Cracking sound can be heard during operations.
●
Occasionally knocking sound is heard.
●
1
Select the
desired
operation.
����
��� ����
����
2
Start the
operation.
3
Set the
temperature.
(16ºC ~ 30ºC)
button again to stop the operation.
COOL
AUTO
AUTO
AUTO
FAN
TEMP
OFF/ON
MODE QUIET POWERFUL
AIR SWING
FAN SPEED
1 2 3
ON SET
OFF CANCEL
TIMER
CHECK RESET CLOCK
For DK-series
indoor unit
The operating mode is different from other indoor unit.
➤
This is a normal self protection control.
➤
Caused by refrigerant flow inside.
➤
Panel expanding/contracting due to change in temperature.
➤
Switching over of refrigerant gas in the system during defrosting and at
➤
the end of operations.
■ Operation Details
AUTO - Automatic Operation
• The unit will automatically select
the operation mode according
to the setting, outdoor and room
temperature. During operation mode
selection, power indicator blinks. For
every 3 hours, the operation mode is
reselected.
HEAT - Heating Operation
• Enables you to enjoy the warming
effect at your preferred setting
temperature.
• For cold air prevention, air might
not blow out immediately and power
indicator blinks when operation
starts.
• Also operates in defrost mode
(maximum 12 minutes) where by the
power indicator blinks. The melted
frost is drained at outdoor unit and
indoor fan is stopped.
COOL - Cooling Operation
• Enables you to enjoy the cooling
effect at your preferred setting
temperature.
DRY - Soft Dry Operation
• Enables you to set the desired
temperature at low fan speed which
provides you with the dehumidifying
surroundings.
7