Publicidad
Idiomas disponibles
Idiomas disponibles
1. Remove
wing n ut f rom shield.
2. Insert bracket into slot a s shown.
3. Pivot shield u ntil bolt p asses
through hole inbracket.
4. Securely
tighten wing nut o nto bolt.
Slot
Wing Nut
Bracket
_/
St
Gearbox
Shield
KNOW YOUR TRIMMER
READ THIS iNSTRUCTiON MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT. Compare the illustrations with your unit to familiarize yourself with the location of
the various controls and adjustments.
Save this manual for future reference.
Shaft
Line Limiter
Blade
STO P
Spark Plug
Muffler
Primer Bulb
ThrottIe Trigger
--Start
Lever
Fuel Mix Fill Cap
Starter Handle
STOP SWITCH
The STOP switch is used to stop the en-
gine. To stop the engine, push and hold
the switch in the STOP position until the
engine stops.
PRIMER BULB
The PRIMER BULB removes
air from
the carburetor
and fuel lines and fills
them with fuel. This allows you to start
the engine with fewer pulls on the
starter rope. Activate the primer bulb
by pressing it and allowing it to return
to its original form.
START LEVER
The START LEVER helps to supply fuel
to the engine to aid in starting. Acti-
vate the starting system by moving the
start lever to the START position. DO
NOT squeeze
the throttle trigger until
the engine has started and runs. After
the engine starts, allow the engine to
warm-up
10 seconds, then fully
squeeze
the throttle trigger to deacti-
vate the starting system.
BEFORE STARTING
ENGINE
,_WARNING:
Be sure to read
the fuel information
in the safety rules
before you begin. If you do not
understand
the safety rules, do not
attempt to fuel your unit. Call
1-800-235-5878.
FUELING
ENGINE
_WARNING:
Remove fuel cap
slowly when refueling.
This engine is certified to operate on
unleaded gasoline.
Before operation,
gasoline
must be mixed with a good
quality synthetic
2-cycle air-cooled
engine oil.
5
Publicidad
