Monster TULPAR T7 V24.1 Manual Del Usuario página 7

4. Press F10 to "Save and Exit" and select <Yes>, however note below.
• Make sure the Windows 10 OS (DVD) is in the attached DVD drive or on a USB flash drive and as the
computer starts up it will automatically boot from the Windows 10 OS DVD or USB flash drive
5. Click Next > Install Now to continue installing the operating system as normal
(see your Windows documentation if you need help on installing the Windows OS)
6. Select Custom: Install Windows only (advanced).
7. It is recommended that you select and then delete existing partitions.
8. Click New to create a partition for Windows.
9. It is very important to make sure that when you create the partition, leave at least a
minimum of unallocated space of 5MB. This space is required for any drive that is being
accelerated (System or Data Drive)
10. Follow the on-screen instructions to install the Windows 10 operating system.
11. Install the Windows drivers. Make sure you install the Intel® Rapid Storage Technology
(IRST) driver.
12. Run the Intel® Optane™ Memory and Storage Management application.
13. Click Enable Intel® Optane™ Memory.
14. A warning will pop up to notify you that all data on the Optane Memory Module will be
erased, and if this is OK then click Enable.
15. The system will prepare and enable the Optane drive, and when finished you can then
click Restart.
16. The system will then optimize the Optane Memory upon restart.
17. Run the Intel® Optane™ Memory and Storage Management application.
18. The system status will then be displayed.
Disabling Intel® Optane™
If you wish to disable an existing Intel® Optane™ setup then follow the procedure below to
do so.
1. Run the Intel® Optane™ Memory and Storage Management application.
2. Click Intel® Optane™ Memory and then click Disable.
3. Click Disable when you see the following message.
Figure 2 - Intel® Optane™
Memory and Storage Management -
Enable Intel® Optane™ Memory
EN
07