Klarstein SARTHE Manual Del Usuario página 15

FIXING THE WATCH IN PLACE
The watch holder can accommodate watches with a maximum diameter of
53 mm. The watch may be a maximum of 20 mm thick. The circumference of the
strap must be between 35-62 mm.
Note: If the strap is too short, you can push out the detachable part at the
bottom and then put the watch in place.
How to fix the watch in place
1 Remove the watch holder from the device by pulling the two tabs on the
side.
2
Close the strap of your watch.
3
Pinch the watch mount and slide your watch over the mount.
4
Slide the watch holder into the device until you hear a click.
Part
removable
EN
15