AirComfort DEEP SLEEP 6105QRB Manual De Instrucciones

DE E P S L EEP Q UEEN R A I SED A I R MAT TR E S S
INSTRUCTION MANUAL MODEL# 6105QRB
DISCLAIMER:
GREAT CARE AND ATTENTION HAS BEEN TAKEN TO ENSURE THE QUALITY OF THIS PRODUCT. WE
ARE NOT LIABLE FOR ANY ACTIONS THAT MAY RESULT IN INJURY, DEATH, DAMAGE TO PROPERTY,
OR LOSS OF INCOME.
LIMITED WARRANTY:
THIS AIR BED IS GUARANTEED TO BE FREE FROM DEFECTS IN MATERIALS AND WORKMANSHIP FOR
1 YEAR AT THE TIME OF PURCHASE. ANY DAMAGE THAT OCCURS AFTER PURCHASE AS A RESULT
OF NORMAL USE SCUFFS OR PUNCTURES IS NOT COVERED BY THIS WARRANTY AND IS THE SOLE
RESPONSIBILITY OF THE CUSTOMER.
INFLATING WITH EMERGENCY FILL VALVE:
IN THE EVENT OF A FAILURE OF THE BUILT IN PUMP, THIS BED IS EQUIPPED WITH A SECONDARY
INFLATION VALVE. EXTEND SMALL VALVE OUT FROM SIDE OF BED. OPEN VALVE CAP AND FILL BED
WITH EXTERNAL PUMP NOT INCLUDED . DO NOT USE A HIGH PRESSURE PUMP. A MANUAL PUMP
SUCH AS A FOOT PUMP OR BIKE PUMP WITH ADAPTER IS RECOMMENDED. CLOSE VALVE CAP
AND PUSH VALVE BACK INTO BED WHEN DONE. DO NOT OVERINFLATE.
CUSTOMER SERVICE: 866 498 5269 | CUSTOMERSERVICE GQBRANDS.COM / WEB: AIRCOMFORTBEDS.COM / ADDRESS: 4401 SAMUELL BLVD, STE 150, MESQUITE, TX 75149
General Care and Maintenance Instructions
Do not let product come in Do not smoke while
contact with tools, pets, or using. Keep away from
sharp objects that may open ames.
puncture material.
Important Safety Information and Warnings:
• Do not over or under in ate
• CAUTION: After in ation, a change to hot weather will
cause air to expand. You must release air to prevent
airbed from de ating due to overpressure. A change to
cold weather will cause air to contract. You may need to
add air to maintain rmness.
• Avoid using in extreme temperatures.
• Keep away from sharp edges, nails, or any sharp or
pointed objects.
• Do not stand, walk, or jump on bed. Do not allow
children to play or jump on bed.
• Keep away from open ame and heaters.
Setting Up / Storing Away
In ating:
1) Check your sorroundings for any sharp objects
on the ground/ oor that may cause damage
to the bed (nails, screws, sharp rocks, etc.)
2) Unfold the bed and lay it at on the oor.
3) Ensure the pump is in the "OFF" position.
4) Connect the pump cord to an electrical outlet
as shown.
5) Make sure the air inlet vents are clear of any
obstructions.
6) Rotate the pump knob clockwise to the
"INFLATE" position as shown.
7) When the air mattress reaches the desired
rmness rotate the pump knob back to the
"OFF" position as shown.
DO NOT OVERINFLATE. INFLATE UNTIL THE
WRINKLES IN PVC ARE ALMOST GONE, AND
THE MATTRESS IS FIRM.
Clean product with mild soap Never unfold or in ate
and water only. the product in cold
temperatures.
• Do not smoke on the bed.
• This is not a life saving device. Do not use as a otation or
as a water toy.
• Do not let young children sleep on this mattress until
mature enough to sleep in an adult bed. Young children
can su ocate, especially in the case of unexpected
de ation. Never leave a child unattended or sleep on
same mattress as a young child.
• Fill with cold air only. Never use a hair dryer to in ate.
• Maximum Weight: 500 Lbs/226 Kgs Total.
De ating:
1) Connect the pump cord to an electrical outlet
as shown above.
2) Rotate the pump knob counter-clockwise
past the "OFF" setting to "DEFLATE"
3) Allow the bed to fully de ate, and then turn
the knob to the "OFF" position.
4) Disconnect the pump cord from the outlet
and place it into the cord storage pocket.
5) Fold the bed and place into the carry bag.
OPEN SWITCH