TDK-Lambda DPP120 1 Serie Manual De Instalación página 10

DPP120-XX-1 Installation Manual
Mechanical Outline Drawings:
Front panel indicators:
DC ON - The Green LED is on when the output voltage is >75%.
DC LOW - The red LED is on when the output voltage is between 70 – 90%.
The output can be increased by turning the front panel potentiometer clockwise, turning the potentiometer counter
clockwise will decrease the output.
Adjusting output voltage beyond the stated range may cause overvoltage protection (OVP) to clamp the output. To
reset for normal operation simply adjust the potentiometer to reduce the output voltage to within its range (see table
above)
Power ready signal (Rdy) 24V model only.
Contact closed at start up – threshold voltage 17.6 – 19.4Vdc
Contact electrical isolation 500Vdc
Contact rating 60Vdc/0.3A
Weight: DPP240-xx-1 weighs 920g
TDK-Lambda Germany GmbH
Karl-Bold-Str. 40
D-77855 Achern, Germany
Tel: +49 (0) 7841 6660
Fax: +49 (0) 7841 5000
www.emea.tdk-lambda.com
Page 10 of 10 October 2023 UM000013A01