Publicidad
Idiomas disponibles
Idiomas disponibles
This appliance is not intended for use by persons (including children) with reduced phy-
sical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
1.
Make sure power supply breaker is switched off. Installation must be carried out in accordan-
ce with the current edition of the local wiring regulations code having jurisdiction. Installation
shoul be performed only by a qualified electrician.
2.
Place template against wall at desired height (see mounting height recommendations) and
mark locations of 4 mounting holes and wire service entry at knockout (KO) location.
Note: For two more dryers, dryers should be no closer than 24 inches (610 mm) on center.
1. remove and retain 2 covers
screws and cover.
100
100
152
100
100
100
268
268
268
268
268
2. Insert the power cord into the
opening
3. Connect the wire into terminal as below:
INSTALLATION
152
152
152
152
Connections:
A. Connect the live wire (colored red or brown or white)
to the terminal block where marked "L".
B. Connect the neutral wire (colored black or blue) to the
terminal block where marked "N".
C. Connect the ground wire (colored green and yellow or
green), to the green screw marked "
Note that colors of live and neutral wires depend on voltage of
supply service.
4. Fix the base plate to the wall
with 4 screws of 1/4" x 1-1/2"
dimension.
5. Put the front cover back and
screw it with L key.
7
".
EN
Publicidad
